3/8 X 3-3/4” 30 | 38 | 24 |
| |
| 1 | 43 |
| |
| 42 | |
| | 34 |
31 3/8 X 8-3/4” | | |
36 | | |
44 | | |
| 9 | |
| 27 | |
| 3/8 X 1-3/4” | |
FIGURE 14 | | 12 |
STEP 14:
•Refer to cable ILLUSTRATION “A” on page 14 for cable routing while installing pulleys.
•Assemble one 3-1/2” PULLEY (24) into the PRIMARY PIVOT (9) lower hole using one 3/8 X 8-3/4” BOLT (31),
two 3/8” FLAT WASHERS (36), two 3/8 X 1-1/2” SPACERS (44) and one 3/8” LOCK NUT (34) and tighten securely.
•Assemble one 3-1/2” PULLEY (24) to the FRAME (1) using one 3/8 X 3-3/4” BOLT (30), two 3/8 X 1-1/16” FLANGE SPACERS (42), one 3/8” LOCK NUT (34) and tighten securely
•Loosely assemble one 3-1/2” PULLEY (24) between PULLEY PLATES (12) using one 3/8 X 1-3/4” BOLT (27) and one 3/8” LOCK NUT (34).
•Assemble two 3-1/2” PULLEYS (24) between the left and right BOOM PLATES (4) and (5) using two 3/8 X 3-3/4” BOLTS (30), two 3/8 X 1” SPACERS (43), two 3-1/2” CABLE GUARDS (38) and two 3/8” LOCK NUTS (34)
| 1/2 | | 1/2 | | 1/2 | | 1/2 | | 1/2 | | | 1/2 | |
0 | | | 1 | | | 2 | | | 3 | | | 4 | | | 5 | | 6 |
| | | | | | | | | | | | | | | | | | | | | | | | |
16
