| | | 73 | | | |
| 38 | | | | | |
| | | | | 7 | |
| | | | | | BLACK |
| | | | | | 77 |
| | | | | | 73 |
| 76 | 1 | 45 | 38 | | 49 |
| 75 | | | | | |
78 | 62 3/8 X 1-3/4” (43m) | | | | | |
| | | 76 55 | | | |
| | 3/8 X 3-3/4” (93m) 66 | 75 | | | |
| | | | 2 | 62 3/8 X 1-3/4” | (43m) |
| | | | | |
FIGURE 33 | 78 | | | | |
| | | | |
STEP 33:
•Route the LEG CABLE (45) through the bracket on the BASE (1) and assemble one 4-1/2” PULLEY (38) to the bracket on the BASE (1) using four RH CAPS (78), two 3/8 X 1-3/4” BOLTS (62), four 3/8” SAE WASHERS (75), four 3/8” RH WASHERS (76) and two 3/8” LOW HEIGHT LOCK NUTS (73) as shown in FIGURE 33.
•Route the LEG CABLE (45) through the BENCH FRAME (2) and assemble one 4-1/2” PULLEY (38) to the BENCH RAME (2) using one RH CAP (78), one BLACK RH CAP (77), one 3/8 X 3-3/4” BOLT (66), two 3/8 X 1”FLANGE SPACERS (55), two 3/8” SAE WASHERS (75), two 3/8” RH WASHERS (76), one CABLE CLIP (49) and one 3/8” LOW HEIGHT LOCK NUT (73) as shown in FIGURE 33.
•Assemble the swivel end of LEG CABLE (45) to the PEDESTAL (7) using two RH CAPS (78), one 3/8 X 1-3/4” BOLT (62), two 3/8” SAE WASHERS (75), two 3/8” RH WASHERS (76), and one 3/8” LOW HEIGHT LOCK NUT (73). See FIGURE 33.
23
