Life Fitness Fit-1 manual Serial #

Page 25

8

 

 

74

 

71 3/8 X 1” (25m)

24

BUTTON HEAD

 

23

 

20

 

 

SERIAL #

 

LOCATION

FIGURE 35

 

STEP 35:

SECURELY assemble the LEFT and RIGHT SHROUDS (23 & 24) to the STACK BOOM (8) and BOTTOM SHROUD BRACKET (20) using eight 3/8 X 1” BUTTON HEAD BOLTS (71) and eight 3/8” BLACK SAE WASHERS (74) as shown in FIGURE 35.

Adjustments can be made in the above locations to set the correct amount of tension in the cables.

If upon completion of assembly, the HEAD PLATE (29) does not sit on top of the first WEIGHT PLATE (31), push the HEAD PLATE (29) down, insert the WEIGHT STACK PIN (33) and perform several repetitions. This will relax the cable system and prevent the HEAD PLATE (29) from lifting up. See FIGURE 35.

For maximum performance, the HEAD PLATE (29) should just barely sit on the top WEIGHT PLATE (31).

25

Image 25
Contents FIT Series FIT-1 Parts List Height Lock NUT Tools Required for Assembly Step 73m X 2-1/2 67m X 3-1/2 90m 60 3/8 X 1 25m Spring PIN Tighten X 4-1/4 106m Step 67 3/8 X 4-1/4 106m 69 3/8 X 6-1/2 164m Black 53 3/8 X 97m Button Head X 2-1/2 67m Step 100 110 120 130 140 150 X 3/4 X 2-3/4 70m X 1-3/4 62 3/8 X 1-3/4 43m Step 62 3/8 X 1-3/4 43m X 3-3/4 93m Step Serial # Warranty Information