Life Fitness Fit-1 manual Step

Page 17

FIGURE 24

50

 

27

 

29

 

31

58

 

 

30

 

20

 

1

STEP 24:

Insert two GUIDE RODS (27) through the BOTTOM SHROUD BRACKET (20) and into the BASE (1) as shown on FIGURE 24.

(NOTE: Lubricate GUIDE RODS (27) with silicon or teflon spray available at most hardware stores.)

Slide two 3/4 X 2” WEIGHT STACK CUSHIONS (30) down over the GUIDE RODS (27) as shown in FIGURE 24.

Using EXTREME CARE slide all twenty WEIGHT PLATES (31) down over the GUIDE RODS (27) on to the 3/4 X 2” WEIGHT STACK CUSHIONS (30). Make sure that the WEIGHT PLATES (31) are all facing as shown.

Slide the HEAD PLATE ASSY (29) down over the GUIDE RODS (27) onto the weight stack.

Slide two 13/16” SHAFT COLLARS (50) over the GUIDE RODS (27) as shown in FIGURE 7.

Apply WEIGHT STACK LABELS (58) to WEIGHT PLATES (31) and HEAD PLATE (29) as shown in FIGURE 24. Begin with first number on at the HEAD PLATE (29) with larger numbers in consecutive order towards bottom of weight stack.

17

Image 17
Contents FIT Series FIT-1 Parts List Height Lock NUT Tools Required for Assembly Step 73m X 2-1/2 67m X 3-1/2 90m 60 3/8 X 1 25m Spring PIN Tighten X 4-1/4 106m Step 67 3/8 X 4-1/4 106m 69 3/8 X 6-1/2 164m Black 53 3/8 X 97m Button Head X 2-1/2 67m Step 100 110 120 130 140 150 X 3/4 X 2-3/4 70m X 1-3/4 62 3/8 X 1-3/4 43m Step 62 3/8 X 1-3/4 43m X 3-3/4 93m Step Serial # Warranty Information