INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING & MAINTENANCE
WARRANTY |
| |
LIMITED |
| |
10 | ||
| ||
|
|
A S S E M B LY STEP 4
HARDWARE BAG 3 CONTENTS :
FLAT WASHER (B) | NYLON NUT (C) | BOLT (G) |
Qty: 2 | Qty: 1 | Qty: 1 |
CENTER SUPPORT FRAME | |
SEAT SET SAFETY PIN | |
FLAT WASHER (B) | |
SEAT WELDMENT SET | NYLON NUT (C) |
| |
BOLT (G) |
|
FLAT WASHER (B) |
|
LEG EXTENSION/ |
|
CURL DOWN TUBE |
|
CABLE ATTACHMENT | |
AOpen HARDWARE BAG 3.
BAttach LEG EXTENSION/CURL DOWN TUBE to SEAT ASSEMBLY using 1 BOLT (G), 2 FLAT WASHERS (B) and 1 NYLON NUT (C).
NOTE: Position the LEG EXTENSION/CURL DOWN TUBE so the cable attachment is facing the gym.
CInsert SEAT SET SAFETY PIN.
A S S E M B LY STEP 5
HARDWARE BAG 4 CONTENTS : |
|
|
|
FLAT WASHER (B) | NYLON NUT (C) | BOLT (H) | BOLT (L) |
Qty: 6 | Qty: 2 | Qty: 2 | Qty: 2 |
| CENTER SUPPORT FRAME |
SEAT BACK PAD | FLAT WASHER (B) |
| SCREW (H) |
SEAT BOTTOM PAD |
|
NYLON NUT (C) | BOLT (L) |
FLAT WASHER (B) |
|
ADJUSTMENT BAR |
|
END COVER |
|
FOAM ROLLER |
|
LEG EXTENSION/ |
|
CURL DOWN TUBE |
|
AOpen HARDWARE BAG 4.
BAttach SEAT BACK PAD to CENTER SUPPORT FRAME using 2 SCREWS (H), 2 FLAT WASHERS (B).
CAttach SEAT BOTTOM PAD to SEAT WELDMENT using 2 BOLTS (D), 4 FLAT WASHERS (B) and 2 NYLON NUTS (C).
DInstall assembled seat into gym.
EInstall LEG PADS to LEG EXTENSION/CURL DOWN TUBE as shown in diagram.
INTRODUCTION
PRECAUTIONS
IMPORTANT
ASSEMBLY
YOU BEGIN
BEFORE
GUIDELINES
CONDITIONING
TROUBLESHOOTING & MAINTENANCE
| WARRANTY | |
| LIMITED | |
11 | ||
| ||
|
|
SXS_5.7_rev.1.1.indd | 8/30/07 11:12:48 AM |