INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING & MAINTENANCE
WARRANTY |
| |
LIMITED |
| |
14 | ||
| ||
|
|
A S S E M B LY STEP 8
HARDWARE BAG 7 CONTENTS :
CABLE C
Qty: 1
| SINGLE FLOATING |
| PULLEY BRACKET |
FLAT WASHER | CLEVIS |
NYLON NUT | BALL |
| CABLE C |
| FLAT WASHER (B) |
| SCREW (E) |
HOOK |
|
HANDLE |
|
| HANDLE |
AOpen HARDWARE BAG 7.
BRemove NYLON NUT, FLAT WASHER, THREADED SCREW and BALL from end of CABLE C.
CRoute CABLE C through the pulley system in the RADIAL ARM ASSEMBLY as shown in diagram.
NOTE: After threading through one arm of RADIAL ARM ASSEMBLY thread CABLE C up through SINGLE FLOATING PULLEY BRACKET before bringing to back through other arm.
DAfter CABLE C routing is complete replace nylon nut, threaded screw and ball on end of cable.
EHook HANDLES on to cable using the 2 HOOKS.
A S S E M B LY STEP 9
HARDWARE BAG 8 CONTENTS :
CABLE D
Qty: 1
CABLE (D) |
LAT BAR |
BALL |
NYLON NUT |
FLAT WASHER |
CLEVIS |
HOOK |
SCREW (E) |
FLAT WASHER (B) |
AOpen HARDWARE BAG 8.
BRemove nylon nut, threaded screw and ball from end of CABLE D.
CRoute CABLE D through the pulley system in the UPPER PULLEY BRACKET ASSEMBLY as shown in diagram.
DAfter CABLE D routing is complete replace nylon nut, threaded screw and ball on end of cable.
INTRODUCTION
PRECAUTIONS
IMPORTANT
ASSEMBLY
YOU BEGIN
BEFORE
GUIDELINES
CONDITIONING
TROUBLESHOOTING & MAINTENANCE
| WARRANTY | |
| LIMITED | |
15 | ||
| ||
|
|
SXS_5.7_rev.1.1.indd | 8/30/07 11:13:01 AM |