INTRODUCTION
IMPORTANT PRECAUTIONS
A S S E M B LY STEP 2
HARDWARE BAG 1 CONTENTS :
BOLT (A) | FLAT WASHER (B) | NYLON NUT (C) |
Qty: 4 | Qty: 12 | Qty: 6 |
BOLT (D) | SUPPORT PLATE |
|
Qty: 2 | Qty: 2 |
|
A S S E M B LY STEP 3
HARDWARE BAG 2 CONTENTS :
BOLT (A) | FLAT WASHER (B) | NYLON NUT (C) | SCREW (F) |
Qty: 2 | Qty: 4 | Qty: 2 | Qty: 4 |
SCREW (F)
INTRODUCTION
IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING & MAINTENANCE
WARRANTY |
| |
LIMITED |
| |
| ||
|
|
| UPPER PULLEY ASSEMBLY | |
| FLAT WASHER (B) |
|
| NYLON NUT (C) | |
BOLT (D) |
|
|
FLAT WASHER (B) |
|
|
LAT BAR |
|
|
BRACKET ASSEMBLY |
|
|
|
| SUPPORT PLATE |
FLAT WASHER (B) |
| FLAT WASHER (B) |
|
| |
|
| BOLT (A) |
NYLON NUT (C) |
|
|
|
| LEFT SUPPORT |
CENTER | RIGHT | FRAME |
| ||
SUPPORT | SUPPORT |
|
FRAME | FRAME |
|
AOpen HARDWARE BAG 1.
BAttach upper PULLEY assembly to CENTER SUPPORT FRAME using 2 bolts (D), 4 flat washers
(B)and 2 NYLON nuts (C). Tighten this hardware.
CPosition LAT BAR BRACKET ASSEMBLY in line with the
UPPER PULLEY ASSEMBLY and the LEFT SUPPORT FRAME and RIGHT SUPPORT FRAME as shown. Using 4 BOLTS (A), 8 FLAT WASHERS
(B)and 4 NYLON NUTS (C) attach SUPPORT PLATES, LAT BAR BRACKET ASSEMBLY and UPPER PULLEY ASSEMBLY to the LEFT SUPPORT FRAME and RIGHT SUPPORT FRAME as shown.
BACK COVER
FLAT WASHER (B)
NYLON NUT (C)
FRONT COVER 
CENTER SUPPORT FRAME 
FLAT WASHER (B) 
BOLT (A) | RADIAL ARM ASSEMBLY |
SEAT WELDMENT SET
STEP |
RADIAL ARM ASSEMBLY |
STOPPER |
AOpen HARDWARE BAG 2.
BAttach SEAT WELDMENT SET.
CAttach Cover to bolted joint using 4 SCREWS (F).
DRemove STOPPER from front side of RADIAL ARM ASSEMBLY and reinstall on back side of
RADIAL ARM ASSMBLY.
EAttach RADIAL ARM ASSEMBLY to CENTER SUPPORT FRAME using 2 BOLTS (A), 4 FLAT WASHERS (B) and 2 NYLON NUTS (C).
ASSEMBLY
BEFORE YOU BEGIN
CONDITIONING GUIDELINES
TROUBLESHOOTING & MAINTENANCE
LIMITED WARRANTY
SXS_5.7_rev.1.1.indd | 8/30/07 11:12:44 AM |