INTRODUCTION
A S S E M B LY STEP 6
HARDWARE BAG 5 CONTENTS :
BOLT (I) | FLAT WASHER (J) | NYLON NUT (K) | BUMPER |
Qty: 4 | Qty: 8 | Qty: 4 | Qty: 2 |
A S S E M B LY STEP 7
HARDWARE BAG 6 CONTENTS : |
| A | Open HARDWARE BAG 6. |
| CABLE A | B | Remove nylon nut and threaded |
| Qty: 1 | ||
|
| screw from end of CABLE A. | |
|
|
|
INTRODUCTION
IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE YOU BEGIN
CONDITIONING GUIDELINES
TROUBLESHOOTING & MAINTENANCE
LIMITED WARRANTY
FLAT WASHER (J) | GUIDE ROD |
| |
NYLON NUT (K) | TOP WEIGHT |
| BAYONET |
| WEIGHT PLATE |
| SELECTOR PIN |
| BUMPER |
| SCREW (I) |
| FLAT WASHER (J) |
AOpen HARDWARE BAG 5.
BInstall 2 BOLTS (I), 4 FLAT WASHERS (J) and 2 NYLON NUTS (K) into the BASE FRAME as shown in diagram.
CInsert each GUIDE ROD into the BASE FRAME as shown in diagram.
DInstall rubber BUMPER onto each GUIDE ROD.
EInstall each WEIGHT PLATE onto GUIDE RODS
NOTE: Ensure that each WEIGHT PLATE’s selector pin slot faces downward.
FInsert each GUIDE ROD into the corresponding hole in the UPPER PULLEY ASSEMBLY.
GSecure GUIDE RODS in UPPER PULLEY ASSEMBLY using 2 BOLTS (I), 4 FLAT WASHERS (J) and 2 NYLON NUTS (K).
NOTE: Ensure that each bolt is inserted through the hole at the top of the GUIDE ROD.
HTighten all hardware.
12
NYLON NUT (C) |
FLAT WASHER (B) |
BALL |
RUBBER STOP |
CLEVIS |
FLAT WASHER (B) |
SCREW (E) |
CABLE A |
HOOK |
LAT BAR |
DUAL FLOATING |
PULLEY BRACKET |
LAT BAR / WEIGHT |
CABLE SCREW AND NUT |
TOP WEIGHT |
THREAD |
CInsert cable end into LAT BAR ASSEMBLY BRACKET pulley as shown in diagram.
NOTE: After passing through second pulley bracket, DUAL FLOATING PULLEY BRACKET must be installed.
D
EHook LAT BAR on to cable using the HOOK and rest in craddle.
PRECAUTIONS
IMPORTANT
ASSEMBLY
YOU BEGIN
BEFORE
GUIDELINES
CONDITIONING
TROUBLESHOOTING & MAINTENANCE
| WARRANTY | |
| LIMITED | |
13 | ||
| ||
|
|
FS 40 rev 1.0.indd | 8/20/07 11:37:10 AM |