INTRODUCTION
IMPORTANT PRECAUTIONS
A S S E M B LY STEP 2
HARDWARE BAG 1 CONTENTS :
BOLT (A) | FLAT WASHER (B) | NYLON NUT (C) |
Qty: 4 | Qty: 12 | Qty: 6 |
BOLT (D) | SUPPORT PLATE |
|
Qty: 2 | Qty: 2 |
|
A S S E M B LY STEP 3
HARDWARE BAG 2 CONTENTS :
BOLT (A) | FLAT WASHER (B) | NYLON NUT (C) | SCREW (F) |
Qty: 2 | Qty: 4 | Qty: 2 | Qty: 4 |
SCREW (F)
INTRODUCTION
IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING & MAINTENANCE
WARRANTY |
| |
LIMITED |
| |
| ||
|
|
| UPPER PULLEY ASSEMBLY |
| FLAT WASHER (B) |
| NYLON NUT (C) |
BOLT (D) |
|
FLAT WASHER (B) |
|
LAT BAR |
|
BRACKET ASSEMBLY |
|
FLAT WASHER (B) | FLAT WASHER (B) |
| |
| BOLT (A) |
NYLON NUT (C) |
|
| SUPPORT |
| PLATE |
AOpen HARDWARE BAG 1.
BAttach upper PULLEY assembly to CENTER SUPPORT FRAME using 2 bolts (D), 4 flat washers
(B)and 2 NYLON nuts (C). Tighten this hardware.
CPosition LAT BAR BRACKET ASSEMBLY in line with the
UPPER PULLEY ASSEMBLY and the LEFT SUPPORT FRAME and RIGHT SUPPORT FRAME as shown. Using 4 BOLTS (A), 8 FLAT WASHERS
(B)and 4 NYLON NUTS (C) attach SUPPORT PLATES, LAT BAR BRACKET ASSEMBLY and UPPER PULLEY ASSEMBLY to the LEFT SUPPORT FRAME and RIGHT SUPPORT FRAME as shown.
BACK COVER
FLAT WASHER (B)
NYLON NUT (C)
FRONT COVER 
FLAT WASHER (B) 
BOLT (A) | RADIAL ARM ASSEMBLY |
SEAT WELDMENT SET
STEP |
RADIAL ARM ASSEMBLY |
STOPPER |
A Open HARDWARE BAG 2.
B Attach SEAT WELDMENT SET.
C Attach Cover to bolted joint using 4 SCREWS (F).
D Remove STOPPER from front side of RADIAL ARM ASSEMBLY and reinstall on back side of
RADIAL ARM ASSMBLY.
E Attach RADIAL ARM ASSEMBLY to CENTER SUPPORT FRAME using 2 BOLTS (A), 4 FLAT WASHERS (B) and 2 NYLON NUTS (C).
ASSEMBLY
BEFORE YOU BEGIN
CONDITIONING GUIDELINES
TROUBLESHOOTING & MAINTENANCE
LIMITED WARRANTY
FS 40 rev 1.0.indd | 8/20/07 11:37:01 AM |