Life Fitness 8225 manual Head Plate 33 should be on top

Page 9

STEP 10

FIGURE 10

Insert the two GUIDE RODS (15) into the base of the TOWER (3) as shown in FIGURE 10. Lubricate the GUIDE RODS (15) with a slicon or teflon spray that is available at most hardware stores.

Slide two WEIGHT STACK CUSHIONS (36) down over the GUIDE RODS (15). See FIG- URE 10.

Using EXTREME CARE slide fifteen WEIGHT PLATES (35) down over the GUIDE RODS (15) with the key-hole facing as shown in FIGURE 10.

Securely assemble the WEIGHT STACK SHAFT (32) to the HEAD PLATE (33) using one 3/8 X 1-1/4” BOLT (20) and one 3/8” WASHER (25). (Note: The bolt hole in the

HEAD PLATE (33) should be on top.)

Carefully Slide the HEAD PLATE ASSEM- BLY (32 & 33) down over the GUIDE RODS (15) onto the weight stack as shown in FIG- URE 10.

Slide two 13/16” SHAFT COLLARS (31) over the GUIDE RODS (15) as shown in FIGURE 10.

Insert the SELECTOR PIN (34) into the WEIGHT STACK as shown.

Apply one set of WEIGHT STACK LABELS - LBS. OR 1-25 (38) (39) to each WEIGHT PLATE (35) as shown in FIGURE 10.

31

 

15

 

33

 

25

 

20 3/8 X 1-1/4”

32

 

35

 

38

39

 

34

36

 

3

 

9

 

Image 9
Contents BICEP/TRICEP Machine Bolt Length Ruler Parts List Step URE X 4 X 1-1/4 Long Side PAD Head Plate 33 should be on top Step Sure the cable runs in the groove of the Pulley Step Pulley Block Assembly Step Button Head Step