Evo Fitness 53553 owner manual FIG-9

Page 11

ASSEMBLY

Step 4:

Attach the Lat Bar Holder (10) to the Top Frame (9) using two 3/8" x 3" Hex Head Bolts (65), four 3/8" Washers (75) and two 3/8" Nylon Nuts (77). Insert two 1" Bushings (46) and two 1/2" Steel Bushings (52) into the Top Frame (9) as shown in FIG 8. Be sure that the 2” x 3” Rect End Plug (42) is inserted into the Top Frame (9).

Slide the Top Frame (9) over the two Guides (5). Align the mounting holes in the Top Frame (9) with the holes in the Upright (3) then secure with the 1/2" x 4" Hex Head Bolts (60), four 1/2" Washers

(74)and two 1/2" Nylon Nuts (76). Attach the Top Frame (9) to the Rear Upright (4) using two 1/2" x 3" Hex Head Bolts (62), four 1/2" Washers (74) and two 1/2" Nylon Nuts (76) as shown in FIG 9.

FIG-8

FIG-9

assemblyinstructions

-11-

Page 10 Page 12
Image 11
Page 10 Page 12
Contents EVO Sierra Home Gym Before Beginning PreassemblyMajority of the Listed Hardware is Already in Place Parts listMajority of the Listed Hardware is Already Place16 X 1/2 Sunken Head Bolt Many Parts Shown have Been PRE-ASSEMBLED by the Factory Parts diagramPage FIG-1 FIG-2 FIG-3 AssemblyInstructions FIG-5 FIG-4FIG-7 AssemblyFIG-9 Assembly instructions FIG-13 Instructions Assembly instructions FIG-15 Assemblyinstructions FIG-T9 TOP Cable FIG-T1FIG-T7 FIG-T8Lower Cable Path Lower Cable FIG-L1FIG-L4 Warranty WarrantyImportant Steps Important stepsExercising Target heart rateYour Target Zone Chart Muscle chartWarm UP Stretching routineCool Down Shoulder Lift Page
Top Page Image Contents