Evo Fitness 53553 owner manual FIG-13

Page 13

ASSEMBLY

Step 6:

Cap the Press Support (14) with two 2" Sq End Plugs (43). Attach two Pop Pins

(57)to the Press Support (14). Attach the Press Support (14) to the Top Frame

(9)using the 1/2" x 7-1/4" Hex Head Bolt (59) and a 1/2" Nylon Nut (76) as shown in FIG 13.

Slide the 1-1/4" Hand Grips (28) onto the Handle Bars (15). If the Hand Grips

(28)are difficult to slide onto the Handle Bars (15) try applying a small amount of soapy water to the Handle Bars (15) prior to sliding on the grips. Attach the Handle Bars (15) to the Press Support

(14)using one 3/8" x 2-3/4" Hex Head Bolt (66), one 3/8" x 3" Hex Head Bolt (65), four 3/8" Washers (75) and two 3/8" Nylon Nuts (77) for each as shown in FIG 14.

FIG-13

assemblyinstructions

FIG-14

-13-

Page 12 Page 14
Image 13
Page 12 Page 14
Contents EVO Sierra Home Gym Before Beginning PreassemblyMajority of the Listed Hardware is Already in Place Parts listMajority of the Listed Hardware is Already Place16 X 1/2 Sunken Head Bolt Many Parts Shown have Been PRE-ASSEMBLED by the Factory Parts diagramPage Instructions AssemblyFIG-1 FIG-2 FIG-3 FIG-5 FIG-4FIG-7 AssemblyFIG-9 Assembly instructions FIG-13 Instructions Assembly instructions FIG-15 Assemblyinstructions FIG-T7 TOP Cable FIG-T1FIG-T8 FIG-T9FIG-L4 Lower Cable FIG-L1Lower Cable Path Warranty WarrantyImportant Steps Important stepsYour Target Zone Target heart rateExercising Chart Muscle chartCool Down Stretching routineWarm UP Shoulder Lift Page
Top Page Image Contents