Evo Fitness 53553 owner manual Instructions

Page 14

instructions

ASSEMBLY

assembly

 

Step 7:

Slide a 1-1/4" Foam Pad (29) onto the left Press Arm (16). If the Foam Pad (29) is difficult to slide onto the Press Arm (16) try applying a small amount of soapy water to the Press Arm (16) prior to sliding on the pad. Insert two 3/4" Bushings (51) into the Left Press Arm (16). Attach the Left Press Arm (16) to the left side of the Press Support (14) using a 1/2" Washer

(74)and 1/2" Nylon Nut (76). Secure using a Pop Pin (57) as shown.

Follow the same procedure to assemble the Right Press Arm (17) to the Press Support (14).

-14-

Page 13 Page 15
Image 14
Page 13 Page 15
Contents EVO Sierra Home Gym Preassembly Before BeginningParts list Majority of the Listed Hardware is Already in PlacePlace Majority of the Listed Hardware is Already16 X 1/2 Sunken Head Bolt Parts diagram Many Parts Shown have Been PRE-ASSEMBLED by the FactoryPage FIG-1 FIG-2 FIG-3 AssemblyInstructions FIG-4 FIG-5Assembly FIG-7FIG-9 Assembly instructions FIG-13 Instructions Assembly instructions FIG-15 Assemblyinstructions FIG-T8 TOP Cable FIG-T1FIG-T7 FIG-T9Lower Cable Path Lower Cable FIG-L1FIG-L4 Warranty WarrantyImportant steps Important StepsExercising Target heart rateYour Target Zone Muscle chart ChartWarm UP Stretching routineCool Down Shoulder Lift Page
Top Page Image Contents