Evo Fitness 53553 owner manual FIG-15

Page 16

instructions

ASSEMBLY

assembly

 

Step 9:

Cap the Leg Curl (19) with two 2" Sq End

Plugs (43). Insert two 1/2" Steel Bushings

(52)into the hole in the Leg Curl (19). Attach the Leg Curl (19) to the Seat Support (18) using the 1/2" Axle (61), two 5/16" x 5/8" Sunken Head Screws (79), two 5/16" Spring Washers (80) and two 5/16" Washers (81). Insert the Bolster

(12)into the hole in the Leg Curl (19) and secure with the 5/16” x 1/2” Sunken Head Bolt (68). Slide one 4" Foam Pad (27) onto each end of the Bolster (12) then cap both ends of the Bolster (12) with a 1" End Plug

(44)as shown in FIG 15. If the Foam Pads (27) are difficult to slide onto the Bolster (12) try applying a small amount of soapy water to the Bolster (12) prior to sliding on the pads.

FIG-15

-16-

Page 15 Page 17
Image 16
Page 15 Page 17
Contents EVO Sierra Home Gym Preassembly Before BeginningParts list Majority of the Listed Hardware is Already in PlacePlace Majority of the Listed Hardware is Already16 X 1/2 Sunken Head Bolt Parts diagram Many Parts Shown have Been PRE-ASSEMBLED by the FactoryPage Instructions AssemblyFIG-1 FIG-2 FIG-3 FIG-4 FIG-5Assembly FIG-7FIG-9 Assembly instructions FIG-13 Instructions Assembly instructions FIG-15 Assemblyinstructions TOP Cable FIG-T1 FIG-T7FIG-T8 FIG-T9FIG-L4 Lower Cable FIG-L1Lower Cable Path Warranty WarrantyImportant steps Important StepsYour Target Zone Target heart rateExercising Muscle chart ChartCool Down Stretching routineWarm UP Shoulder Lift Page
Top Page Image Contents