Evo Fitness 53553 owner manual Instructions, Assembly, FIG-1 FIG-2 FIG-3

Page 8

instructions

ASSEMBLY

assembly

 

Step 1:

Only hand tighten fasteners for now. You will be prompted to fully tighten all fasteners later.

Place the Base Frame (1) on the floor. Cap the Base Frame (1) with the 2" X 3" Rect End Plug (42). Cap the Rear Stabilizer (2) with two 1-3/8” x 3” Rect End Caps (41). Attach the Rear Stabilizer (2) to the Base Frame (1) using two 1/2" x 3" Hex Head Bolts (62), six 1/2" Washers

(74)and four 1/2" Nylon Nuts (76) as shown in FIG 1.

Cap the Upright (3) with the 2" x 3" Rect End Plug (42). Attach the Bumper (45) to the horizontal tube on the Upright (3).

Attach the Pop Pin (56) to the Upright (3). Attach the Stopper (48) to the Upright (3) using the 3/8” x 3/4” Sunken Head Screw (72) as shown in FIG 2.

Attach the Upright (3) to the Base Frame

(1)using two 1/2" x 3" Hex Head Bolts (62), four 1/2" Washers (74) and two 1/2" Nylon Nuts (76) as shown in FIG 3.

FIG-1

 

FIG-2

FIG-3

-8-

Page 7 Page 9
Image 8
Page 7 Page 9
Contents EVO Sierra Home Gym Preassembly Before BeginningParts list Majority of the Listed Hardware is Already in PlacePlace Majority of the Listed Hardware is Already16 X 1/2 Sunken Head Bolt Parts diagram Many Parts Shown have Been PRE-ASSEMBLED by the FactoryPage FIG-1 FIG-2 FIG-3 AssemblyInstructions FIG-4 FIG-5Assembly FIG-7FIG-9 Assembly instructions FIG-13 Instructions Assembly instructions FIG-15 Assemblyinstructions TOP Cable FIG-T1 FIG-T7FIG-T8 FIG-T9Lower Cable Path Lower Cable FIG-L1FIG-L4 Warranty WarrantyImportant steps Important StepsExercising Target heart rateYour Target Zone Muscle chart ChartWarm UP Stretching routineCool Down Shoulder Lift Page
Top Page Image Contents