STEP 3 – Handlebar Tube Assembly
a) Remove the two Allen Bolts, Washers and Phillips Screw
from the Handlebar Tube. |
|
b) Slip the Handlebar Tube Cover onto the Handlebar Tube as shown. | handlebar |
The Handlebar Tube should lean back towards the back of unit. | tube |
|
opening in
handlebar tube
towards back
c)Remove the wire tie from the wires inside the Main Frame Assembly where the Handlebar Tube will go. Attach the four wires from the Main Frame Assembly to the four wires coming out the bottom of the Handlebar Tube.
d)Insert the Handlebar Tube into the Main Frame Assembly, tucking the wires down into the Main Frame Assembly. Reinsert the Allen Bolts and Washers you removed in (a). Be careful not
to pinch the wires. NOTE: Gently pull the wires up from the
top of the Handlebar Tube to prevent any slack in the | 3a |
wires at the base of the Handlebar Tube. Hand tighten. |
|
phillips
screw 
3d
3b
handlebar tube cover
e) | Secure the Handlebar Tube in place with the | remove allen | |
bolts & washers | |||
| three Allen Bolts, Washers and Nylon Nuts from | 3d | |
| the Fastener Pack. Tighten with the Wrench provided. | ||
| |||
| Also tighten the bolts used |
| bolts & washers |
|
| from step a | |
| in step (d). | M8 x 60mm allen bolts, |
|
f) | Let the Handlebar Tube Cover | M8 washers and M8 nylon nuts | allen bolts, |
| |||
| slip into place. Push it down |
| washers & nuts |
|
| from fastener | |
| gently until it clicks. Secure in |
| pack |
| place with the Phillips Screw |
| 3e |
|
|
| |
| you removed in (a). |
|
|
3c
back of unit
main frame assembly
STEP 4 – Seat Carriage Assembly
a)Remove the Plastic Stoppers and the two small Phillips Screws at the back of the Seat Carriage Tube. Slide off the Carriage End Cap letting it gently hang.
b)Holding the Seat Carriage Assembly by the front of Seat Cushion and the top of the Back Rest, slide it onto the Seat Carriage Tube. Lift up on the Seat Carriage Locking Knob and slide the Seat Carriage Assembly on the Seat Carriage Tube until the Seat Carriage Locking Knob locks into a slot.
STEP 5 – Foot Pedal Assembly
The Foot Pedals and the Foot Pedal Cranks are marked “L” and “R”.
Using the Wrench provided, attach the left Foot Pedal to the left Crank rotating the Wrench
Do not try to turn clockwise. You will strip the threads.
Attach the right Foot Pedal to the right
c)Replace the Plastic Stoppers, Carriage End Cap and Phillips Screws you removed in (a).
d)Plug the wire from the rear of the Seat Carriage Tube into the wires coming from the Handlebar on
the lower back of the Seat Carriage Assembly.
seat carriage locking knob
seat carriage
4a 4c
plastic stoppers
Crank rotating the Wrench clockwise.
left foot
pedal
left |
crank |
left side shown |
looking from the |
tube
4b
4d
phillips
screw
carriage end cap
wire
back of the unit | “L” & “R” | |
markings are | ||
| ||
| located on the | |
| ends of the | |
| pedal shaft. |
7