Fitness Quest Gym1000 manual To Remove the Glideboard

5.	(a) Remove the 2 small safety hitch pins	5a.
	located in the brackets at the base of the	5b.
	right and left rails on the column end
	of the unit.
	(b) Fold down vertical height adjustment
	column and replace pins.
6.	With caution, to avoid pinched	6.
	fingers or hands, lift up at the center
	of the frame and fold the exerciser
	together until it rests firmly on the front
	and back crossbars about 12 inches apart.
	Back	Front
7.	Continue to fold the exerciser together Crossbar
		Crossbar
	until it is completely folded and roll the	12”

exerciser into a closet for storage. To store

under a bed, simply lower the exerciser to the floor and roll under the bed.

→

CAUTION

USE CAUTION WHEN FOLDING THE EXERCISER.

TO REMOVE THE GLIDEBOARD

You can also remove the glideboard if you need to fit the exerciser under a narrow space (between 6” and 8”).

CAUTION

THE GLIDEBOARD WEIGHS APPROXIMATELY 15 LBS. USE CAUTION WHEN

LIFTING IT OFF OF THE EXERCISER. LIFTING INCORRECTLY MAY RESULT IN

USER INJURY.

1.With exerciser laying flat on the floor, disconnect the pulley from the hook on the underside of the glideboard. (The 2 small safety hitch pins should be securely fastened through the brackets at the base of the right and left rails on the column end of the unit.)

2. Next, lift up the glideboard and slide it off the 2.

frame of the exerciser. When the bench is completely off the exerciser, set it aside.

3. Next, remove the 2 small safety hitch pins and fold the exerciser together as described above.

Be sure you reinsert the 2 hitch pins before folding.

— 13 —