17.Leg Lever Assembly. Attach a Bumper (40) to the Seat Frame (7) with a #8 x 1Ó Screw (78).
Press a 2Ó Square Inner Cap (28) into the indicated end of the Leg Lever (41).
Lubricate a 3/8Ó x 3Ó Bolt (53). Attach the Leg Lever (41) to the Seat Frame (7) with the 3/8Ó x 3Ó Bolt and a 3/8Ó Nylon Jamnut (63).
Cable Assembly
18.Locate and open the parts bag labeled ÒCable Assembly and Pulleys.Ó For Cable identification and routing during steps 18Ñ39, refer to the Cable Diagram and Cable ID Chart on page 19.
Identify the Low Cable (72). It is approximately 176Ó long and it has a ball on one end and a bolt on the other.
Route the end of the Low Cable (72) with the ball through the bracket on the Weight Base (5) as shown. Attach the 3 1/2Ó Pulley (24) to the bracket with a 3/8Ó x 2Ó Bolt (54) and a 3/8Ó Nylon Locknut (50).
19.Wrap the Low Cable (72) around a 3 1/2Ó Pulley (24) in the direction shown.
Attach the 3 1/2Ó Pulley (24) and a Cable Trap (25) to the welded tube on the Weight Upright (2) with a 3/8Ó x 3 3/4Ó Bolt (59) and a 3/8Ó Nylon Locknut (50).
Make sure the Cable Trap is oriented as shown.
10
17 | 7 |
| 63 |
| 28 |
| 40 |
| 78 |
| 53 |
| 41 |
| Lubricate |
18 |
|
|
| 24 |
|
|
|
| 54 |
|
|
| 72 |
| 50 |
| 5 |
|
|
| |
| Bracket |
| |
19 |
|
|
|
| 2 |
|
|
|
|
| 59 |
24 |
|
|
|
50 | Welded |
|
|
25 |
|
| |
Tube | 72 |
| |
|
| ||
|
|
|