32.Wrap the High Cable (73) around a 3 1/2Ó Pulley (24) in the direction shown.
Attach the 3 1/2Ó Pulley (24) to the lower half of the Small Pulley Frame (22) with a 3/8Ó x 2Ó Bolt (54) and a 3/8Ó Nylon Locknut (50).
3250
22
54
24
73
33.Wrap the High Cable (73) around a 3 1/2Ó Pulley (24) in the direction shown.
Attach the 3 1/2Ó Pulley (24) and a Cable Trap (25) to the riser on the Weight Base (5) by sliding the Cable Trap and Pulley onto the 3/8Ó x 4 3/4Ó Bolt (46) attached in step 31. Thread a 3/8Ó Nylon Locknut (50) onto the Bolt and tighten it. Make sure the Cable
Traps for both of the Pulleys attached to the riser are oriented as shown in this step and in step 31.
Note: For the sake of clarity, drawing 33A shows some parts removed.
34.Wrap the High Cable (73) around a 3 1/2Ó Pulley (24) in the direction shown.
Attach the 3 1/2Ó Pulley (24) and a Cable Trap (25) to the sidearm on the Weight Base (5) by sliding the Pulley and Cable Trap onto the 3/8Ó x 3 1/2Ó Carriage Bolt (62) inserted earlier. Tighten a 3/8Ó Nylon Jamnut (63) onto the Bolt. Make sure the Cable Trap is ori- ented as shown.
35.Wrap the High Cable (73) around a 3 1/2Ó Pulley (24) in the direction shown.
Attach the 3 1/2Ó Pulley (24) and a Cable Trap (25) to the welded tube on the Seat Base (6) by sliding the Pulley and Cable Trap onto the 3/8Ó x 3 1/2Ó Bolt (56) inserted earlier. Thread a 3/8Ó Nylon Locknut (50) onto the Bolt and tighten it. Make sure the Cable
Trap is oriented as shown.
Note: For the sake of clarity, drawing 35A shows some parts removed.
33A | B |
| 73 |
| Mount |
24 | Pulley |
| Here |
|
|
| 50 |
|
Riser |
| 25 |
|
|
| 46 |
| 5 |
|
|
|
|
| |
34 |
| 63 |
|
|
|
|
|
| |
| 25 |
|
|
|
| 24 |
|
|
|
|
|
|
| 73 |
| 62 |
|
|
|
|
| 5 |
|
|
35A |
|
|
| B |
50 |
|
|
|
|
25 |
|
| 73 | Mount |
|
|
| ||
|
|
|
| |
|
|
|
| Pulley |
| 24 |
|
| Here |
|
|
|
| |
| Welded |
|
|
|
| Tube | 56 | 6 |
|
|
|
|
14