Assembly

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included hex keys and your own Phillips screwdriver , adjustable

wrench , and a a rubber mallet .

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the parts bag, check to see if it has been preassembled.

M8 Split	M10 Split	Wave Washer	M8 Large
Washer (100)–4	Washer (70)–2	(95)–2	Washer (53)–10
M4 x 16mm	M4 x 22mm	M8 Nylon	M10 Nylon
Screw (66)–4	Screw (91)–2	Locknut (46)–8	Locknut (29)–4
M8 x 25mm Patch	M8 x 45mm Button		M8 x 50mm Button
Screw (22)–2	Bolt (50)–4		Screw (89)–4
M8 x 65mm Button Screw (99)–4		M10 x 52mm Bolt Set (27)–2
	M10 x 112mm Carriage Bolt (34)–4
	M10 x 88mm Button Screw (63)–2
	5