7.Apply a thin film of grease to the shaft of an
M10 x 52mm Bolt Set (27) and to the surfaces of the two Leg Bushings (28) in the left Handlebar Leg (79).
Next, attach the left Handlebar Leg (79) to the Left Pedal Arm (14) with the M10 x 52mm Bolt Set (27). Do not overtighten the Bolt Set; the left Handlebar Leg must be able to pivot freely.
Attach the right Handlebar Leg (79) to the Right Pedal Arm (103) in the same way.
See step 3. Tighten the M10 x 88mm Button Screws (63). See step 6. Tighten the M8 x 45mm Button Bolts (50) in the Handlebar Legs (79).
8.Attach a Pedal Bracket (16) to the Left Pedal Arm (14) with two M8 x 65mm Button Screws (99), two M8 Large Washers (53), and two M8 Nylon Locknuts (46).
Identify the Left Pedal (13). Attach the Left Pedal to the Left Pedal Arm (14) with two M8 x 50mm Button Screws (89), two M8 Split Washers (100) and two M8 Large Washers (53).
Attach the other Pedal Bracket (not shown) and the Right Pedal (12) to the Right Pedal Arm (103) in the same way.
7
79
79
Grease103
28 | 27 |
28 |
Grease 
27 |
|
|
| 14 |
|
8 |
|
|
| 103 | 12 |
|
| 46 |
14 |
| 53 |
|
| |
| 53 | 13 |
16 | 100 | 53 |
99 |
| |
89 |
| |
|
|
9.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the ellip- tical exerciser.
8