Star Trac Bike Computer manual Installation Procedure V Bikes, Time required, Parts required

Page 14

Installation Procedure V Bikes

Time required:

•15 Minutes

Parts required:

•727-0083 Spinning® Computer Kit NOTE: The thick insert is used on the V bikes

Tools required:

•

•

M5 Allen Wrench

M2 Allen Wrench

4. Place the thick insert inside the bottom part of the Mounting Bracket Clamp. Then position the mounting bracket onto the center-curved portion of the handlebars. Once positioned correctly, tighten the 4 M6x20 screws using the M5 Allen tool.

5. Install the computer onto the mounting bracket by sliding the computer clamp over the long portion of the bracket. Tighten computer clamp with the M6 screw and nut using the M5 Allen tool.

11

Image 14

Contents Spinning Computer Page Table of Contents FCC Regulatory Statements Parts List All 727-0083 Spinning Computer Kits includeParts List- cont’d Computer Window and Buttons ButtonsSetup mode options Setup ModeTo activate Set-Up Mode Setup Mode- cont’d Setup Mode- cont’d Sync Mode Press Reset ButtonRe-Syncing process Installation of Cadence Sensor All Spinners Parts required Installation Procedure V BikesTime required Tools requiredInstallation Procedure Pro 5800 / 6800 / Elite Installation Procedure Elite 6900 and NXT Installing or Replacing the Batteries Low Battery IndicatorFAQ’s and Troubleshooting FAQ’s and Troubleshooting cont’d Specifications Computer Heart Rate RangeMarketing Statement Regarding Heart Rate Layout Diagram = Daily = Weekly Maintenance ChecklistPreventative Maintenance Procedure Spinning Education 50%-65% 65%-75% 75%-85% 65%-92% 80%-92% Energy ZonesEnergy Zone Intensity Range Purpose What is Cadence? Cadence Range for Flat Roads 80-110 RPMPage Tips for Choosing AN Appropriate Cadence and Resistance Relationship Between Cadence and Resistance Cadence Drills Page Page Elapsed Time Duration Intensity TechniqueAdd resistance to moderate/heavy and combine all three Page Http//support.startrac.com