JVC P-VSDT6 manual Presetting Stations, Manual Presetting, Using the Tuner, 3Press the SET button

Page 19

Using the Tuner

Using the Tuner

Presetting Stations

(Using the Remote Control)

You can preset up to 30 FM stations and up to 15 AM (MW/ LW) stations.

•Preset numbers may have been set to factory test fre- quencies prior to shipment. This is not a malfunction. You can preset the stations you want into memory by following one of the presetting methods below.

Manual Presetting

SET	STORED
FM/AM
SET	SET

		or
	When changing the	FM = 30, AM = 15
	Band	FM = 30, AM = 15
	Band

1Select a band by pressing the FM/AM button.

2Press the 4 or ¢ ( or ) button to tune in a station.

3Press the SET button.

“SET” will blink for 5 seconds.

Within 5 seconds, proceed to the next step.

When the display returns to the one set in step 2 after 5 seconds, press the SET button again.

4 Press the > or < button within 5 seconds to select the preset number.

> or < button:	Increase or decrease the preset
	number by 1.
	Pressing and holding the button
	will rapidly increase or decrease
	the preset number.

5 Press the SET button within 5 seconds.

“STORED” appears and after 2 seconds, the display re- turns to the broadcast frequency display.

6 Repeat above steps 1 to 5 for each sta- tion you want to store in memory with a preset number.

To change the preset stations, repeat the same

steps as above.

CAUTION:

•Even if the system is unplugged or if the power failure occurs, the preset stations will be stored for about 24 hours. However, in case the preset stations are erased, you will need to preset the stations again.

16

Image 19

Contents Consists of CA-VSDT7Rand SP-VSDT6 VS-DT6R/VS-DT7R/VS-DT9RCOMPACT COMPONENT SYSTEM Consists of CA-VSDT6Rand SP-VSDT6Warnings, Cautions and Others SAFETY INSTRUCTIONS Introduction Features1Installation of the System 2Power cordSpecifications Table of ContentsHow To Put Batteries In the Remote Control AccessoriesGetting Started Rear Panel of the Center Unit Connecting the FM AntennaUsing the Supplied Wire Antenna Using the Coaxial Type Connector Not SuppliedThe AM loop antenna can be attached to a wall Connecting the AM MW/LW AntennaRear Panel of the Center Unit Getting StartedRemoving the speaker grilles Connecting the SpeakersWhen removing When attaching the speaker grillesSignal cord not supplied Connecting a SubwooferConnecting External Equipment Signal cord not suppliedCAUTIONS Connecting an MD Recorder, etc Digital OutputConnecting the AC Power Cord Installing the Unit on the StandCAUTIONS Installing the Equipment on the WallExample of attachment Center Unit Getting StartedExample of attachment Speakers SP-VSDT6only Changing the Display and Control Buttons SettingsWhen the Unit is placed vertically When the Unit is placed horizontallyGetting Started Using the Remote ControlCOMPU Play On the Remote ControlBasic Operations Turning the Power On and OffAdjusting the Brightness DIMMER When the System is Turned OnFor private listening Adjusting the Volume2Press the COLOR button on the Remote Control Changing the Color COLOR VS-DT9RonlyTone Control BASS/TREBLE on the Remote ControlReinforcing the Bass Sound AHB PRO Showing the Time DISPLAY1Press the FM/AM button Using the TunerTuning In a Station One Touch Radio1Select a band by pressing the FM/AM button Presetting StationsManual Presetting Using the TunerUsing the Tuner To show the RDS signals on the displayTo Change the FM Reception Mode Receiving FM Stations with RDS10 seconds again To search for a programme by PTY codesControl 3 Press the PTY SEARCH button withinUsing the Tuner To select a programme typeWhen playing a CD-Ror CD-RW Using the CD PlayerTo Insert a CD 1 Press the % buttonTo Play a CD Basics of Using the CD Player - Normal PlayUsing the CD Player To Unload a CDChild Lock To Modify the ProgramRandom Play Repeating Tracks2 Start playing the external equipment Using External EquipmentListening to External Equipment 1Press the MD/AUX button4 Press the SET button Using the TimersSetting the Clock Remote Control to set the hour2 Setting the OFF time Example Setting the Daily TimerUsing the Timers 1Setting the ON time Example1Play a CD or tune in to the desired sta- tion Setting the SLEEP Timer2Press the SLEEP button on the Remote Control 7 Press the % button to turn off the Sys- temMoisture Condensation Care And MaintenanceCleaning the unit Compact DiscsAction TroubleshootingSymptom Possible CauseSpecifications