JVC P-VSDT6, LVT0853-009B manual Troubleshooting, Symptom, Possible Cause, Action

Page 31

Troubleshooting

Troubleshooting

•If you are having a problem with your System, check this list for a possible solution before calling for service.

•If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as your dealer, for service.

Symptom

No sound is heard.

Poor radio reception

The CD skips.

The CD does not play.

Unable to operate the Remote Control.

Operations are disabled.

“CD NO DISC” appears.

“CANNOT PLAY” or “UNFINALIZ” appears.

The characters and symbols on the display appear upside down.

Possible Cause

•Connections are incorrect, or loose.

•Headphones are connected.

•The antenna is disconnected.

•The AM Loop Antenna is too close to the System.

•The FM Wire Antenna is not properly extended and positioned.

The CD is dirty or scratched.

The CD is upside down.

•The path between the Remote Control and the sensor on the Unit is blocked.

•The batteries have lost their charge.

The built-in microprocessor has malfunctioned due to external electrical interference.

There is no disc loaded.

•The CD-R or CD-RW that hasn’t yet been finalized (including blank discs) has been inserted.

•The disc has been inserted with its label side down.

The DISP.SET switch on the rear panel of the Center Unit has not been set correctly.

Action

•Check all connections and make corrections. (See pages 4 to 8.)

•Disconnect the headphones.

•Reconnect the antenna securely.

•Change the position and direction of the AM Loop Antenna.

•Extend FM Wire Antenna to the best reception position.

Clean or replace the CD.

Put the CD in with the label side up.

•Remove the obstruction.

•Replace the batteries.

Unplug the System then plug it back in.

Insert a disc.

•Insert a CD-R or CD-RW that has been finalized.

•Remove the disc and insert it with the label side front or up. (See page 20.)

Set the DISP.SET switch correctly. (See page 10.)

28

Image 31

Contents Consists of CA-VSDT7Rand SP-VSDT6 VS-DT6R/VS-DT7R/VS-DT9RCOMPACT COMPONENT SYSTEM Consists of CA-VSDT6Rand SP-VSDT6Warnings, Cautions and Others SAFETY INSTRUCTIONS Introduction Features1Installation of the System 2Power cordSpecifications Table of ContentsHow To Put Batteries In the Remote Control AccessoriesGetting Started Rear Panel of the Center Unit Connecting the FM AntennaUsing the Supplied Wire Antenna Using the Coaxial Type Connector Not SuppliedThe AM loop antenna can be attached to a wall Connecting the AM MW/LW AntennaRear Panel of the Center Unit Getting StartedRemoving the speaker grilles Connecting the SpeakersWhen removing When attaching the speaker grillesSignal cord not supplied Connecting a SubwooferConnecting External Equipment Signal cord not suppliedCAUTIONS Connecting an MD Recorder, etc Digital OutputConnecting the AC Power Cord Installing the Unit on the StandCAUTIONS Installing the Equipment on the WallExample of attachment Center Unit Getting StartedExample of attachment Speakers SP-VSDT6only Changing the Display and Control Buttons SettingsWhen the Unit is placed vertically When the Unit is placed horizontallyGetting Started Using the Remote ControlCOMPU Play On the Remote ControlBasic Operations Turning the Power On and OffAdjusting the Brightness DIMMER When the System is Turned OnFor private listening Adjusting the Volume2Press the COLOR button on the Remote Control Changing the Color COLOR VS-DT9RonlyTone Control BASS/TREBLE on the Remote ControlReinforcing the Bass Sound AHB PRO Showing the Time DISPLAY1Press the FM/AM button Using the TunerTuning In a Station One Touch Radio1Select a band by pressing the FM/AM button Presetting StationsManual Presetting Using the TunerUsing the Tuner To show the RDS signals on the displayTo Change the FM Reception Mode Receiving FM Stations with RDS10 seconds again To search for a programme by PTY codesControl 3 Press the PTY SEARCH button withinUsing the Tuner To select a programme typeWhen playing a CD-Ror CD-RW Using the CD PlayerTo Insert a CD 1 Press the % buttonTo Play a CD Basics of Using the CD Player - Normal PlayUsing the CD Player To Unload a CDChild Lock To Modify the ProgramRandom Play Repeating Tracks2 Start playing the external equipment Using External EquipmentListening to External Equipment 1Press the MD/AUX button4 Press the SET button Using the TimersSetting the Clock Remote Control to set the hour2 Setting the OFF time Example Setting the Daily TimerUsing the Timers 1Setting the ON time Example1Play a CD or tune in to the desired sta- tion Setting the SLEEP Timer2Press the SLEEP button on the Remote Control 7 Press the % button to turn off the Sys- temMoisture Condensation Care And MaintenanceCleaning the unit Compact DiscsAction TroubleshootingSymptom Possible CauseSpecifications