Mounting Cadence hard- ware- In order to use the cadence option you must install the cadence wire provided with your Turbo® Pro. Plug the wire into the socket on the bottom of your computer. Run the cadence sensor wire along the head tube, down tube and along one of the chain stays of your bicycle. Secure it into place using the provided tie-wraps. (See figure 7). Next, attach the cadence magnet to the
6
inside of your crank arm directly across from the sensor. Use a tie-wrap to fasten the magnet to the crank arm. (See figure 8). Do not tighten the tie-wrap until final placement of the magnet is correct. The clearance between the magnet and the sensor should be approximately 1/32”-1/16” (1-2mm). (See figure 9). Tighten the magnet and sensor.
OPERATION AND
PROGRAMMING When your Turbo® Pro has not detected any speed input for 30 minutes, it will enter sleep-mode in order to con- serve battery power. During sleep mode only the digital clock is displayed. You will need to wake it up by push- ing the “Mode” or “Set” but- ton once. In order to operate your computer it must be placed in various “modes” (i.e. odometer mode, dis- tance mode). The computer can be cycled through these modes by pressing the “MODE” button located on the right-hand side the
MODE/SET rocker switch. There are eight cycling modes available: 1) Clock Mode, 2) Distance Mode, 3) Speed Mode, 4) Timer Mode, 5) Cadence Mode, 6) Countdown Mode, 7) Altitude Mode and 8) Temperature Mode. Within each mode there is a side- mode that will allow you to access additional informa- tion such as average and maximum speeds. Use the “SET” button, located on the left-hand side the MODE/SET rocker switch, to cycle through the side- modes. Once you familiarize yourself with the mode/side- mode operation you will find it very easy to navigate. The following flowchart outlines the mode/side-mode sequence. Once a particular mode has been entered, its values can be reset or adjusted by pressing and holding the “SET ” button for three seconds.
1.Setting the Display Language Your Turbo® ® Pro can display information on the
CLOCK
I
TRIP – ODO
I
AVSPD – MXSPD
I
ATM – TIMER
I
CAD – AVCAD – MXCAD
I
INT – Dist
I
ALTI – ALTI –%GRD
I
TEMP ˚F – TEMP ˚C
dot-matrix display area in six different languages: English (ENGL), German (GER), French (FR), Italian (ITA), Dutch (NED), and Spanish (ESP). To select your language push the mode button repeatedly until CLOCK is displayed in the Dot-matrix Display Area. Then, depress hold the “MODE” button for three seconds. The selected language will be dis- played. Use the “MODE” button to scroll through the languages. When the selected language is dis- played (default language is English), press the “SET” button once to confirm your selection and exit dis- play language mode.
7
