Altimeter Calibration, Distance Countdown Distú

programmed, press the

“TOP” button to start/stop the countdown. (See fig- ure 15). Note: The shortest interval that can be set is 5 seconds. The backlight function is disabled when the interval timer is run- ning.

8. Altimeter (ALTI)

Your Turbo® Pro contains an extremely accurate altimeter that is capable of recording changes in alti- tude in increments as small as three feet (one meter). This altimeter calculates altitude by precisely meas- uring barometric pressure. Due to normal changes in barometric pressure, you may need to recalibrate your Turbo® Pro on a daily basis. You should be able to find the altitude where you live on a topo- graphical map or by con- tacting a nearby airport.

Altimeter Calibration

To calibrate your altimeter, press the “MODE” button

until “ALTI” appears. Note: if your display says “ALTIÒ” or “%GRD”, press the “SET” button to change to “ALTI”. Then press the “SET” button for three sec- onds. The first altitude digit will begin flashing. Press the “MODE” button until the desired number appears. Press the “SET” button once to set this num- ber and advance to the next. Repeat this process until you have entered the desired altitude. Press the “SET” button to exit pro- gramming mode.

Note: Altitude will be dis- played in feet when speed is measured in miles per hour and in meters when speed is measure in kilo- meters per hour.

9. Altitude Climbed

The Altitude Climbed func- tion on your Turbo® Pro calculates the total altitude gained during your ride. Descended altitude is not counted. To reset the Altitude Climbed to zero,

press and hold the “SET” button for three seconds.

10.Distance Countdown (DISTÚ)

Your Turbo® Pro is equipped with Distance Countdown feature. This allows you to set an alarm when the selected mileage is reached. To enter the Distance Countdown mode, press the “MODE” button repeatedly until “DISTÚ” appears in the Dot-matrix Display Area. Note: if your display says “INT, press the “SET” button to change to “DISTÚ” To set the Distance Countdown, hold the “SET” button for three seconds. The hour digit will begin flashing. Press the “MODE” Button until the desired number appears. (Hold down the “Mode” button to scroll quickly) Press the “SET” button once to set this number and advance to minutes. Repeat this process until minutes and seconds are set to the desired settings. Press the “SET” button to exit pro-

gramming mode. Once the time interval timer is programmed, press the “TOP” button to stop and start the Distance Countdown. The backlight function is disabled when the Distance Countdown is running.

Note: The shortest distance that can be set is .01 miles/km.

COMPUTER

FUNCTIONS

Speedometer (SPEED)- Your current speed is always displayed in large digits on the top line of the LCD screen. The speed is dis- played up to 99.9 M/h (99.9 Km/h) with a resolu- tion of 0.1 M/h (0.1 Km/h)

Average Speed (AVSPD)- The Average Speed is shown on the lower line Digital Display Area up to

99.9M/h (99.9 Km/h) with a resolution of 0.1 M/h (0.1 Km/h)

The average speed is based upon the ATM time.