JVC M45 manual AM MW loop antenna, FM antenna

Page 14

Getting started

Connecting the FM and AM (MW) antennas

Make sure the antenna conductors do not touch any other terminals, connecting cords and power cords. This could cause poor reception.

7AM (MW) loop antenna

Setting up supplied AM (MW) loop antenna

Attach the AM (MW) loop to its base by snapping the tabs on the loop into the slot on the base.

If the antenna cord is covered with the insulation coat, twist and pull the insulation coat off and remove.

Connecting AM (MW) loop antenna

Center unit

Press and hold down the terminal clamp.

Insert the antenna cord.

If reception is poor

Connect an outdoor single vinyl-covered wire antenna (not supplied) to the AM EXT terminal. (Keep the AM (MW) loop antenna connected.)

• Twist together both wires.

AM (MW) loop antenna

Outdoor single vinyl-covered wire antenna (not supplied)

7FM antenna

Connecting supplied FM antenna

Center unit

Extend the supplied FM antenna horizontally.

If reception is poor

Connect an outdoor FM antenna with standard type (75 C coaxial) connector.

Outdoor FM antenna (not supplied)

Outdoor FM antenna cord (not supplied)

Release finger from the clamp.

• Turn the loop antenna until you have the best reception.

NOTE

•Disconnect the supplied FM antenna before attaching a 75 C coaxial connector (the kind with a round wire going to an outdoor antenna).

•We recommend that you use coaxial cable for the FM antenna as it is well-shielded against interference.

9

Image 14

Contents TH-M45 Important for the U.K Important for Laser Products Class 1 Laser ProductXV-THM45 Safety Instructions Above ALLTable of contents Introduction Supplied accessoriesSafety precautions Important cautionsDiscs you can play About discsPlayable disc types About MP3 discsDisc structure Playback Control function PBC VCD and Svcd onlyRear panel center unit Names of parts and controlsFront panel center unit Names of parts and controls Powered subwooferDisplay window center unit Remote control AUDIO, TV, VCRGetting started Connecting a TVTo connect a TV with the Scart connector ConnectionsAM MW loop antenna FM antennaSpeaker layout Connecting the powered subwooferConnecting the satellite speakers When installing the satellite speakers on the wall Connecting the satellite front, center, surround speakersBefore connecting the speaker cords Twist and pull the insulation coat off and removeConnecting to an analog component Connecting to a digital componentConnecting the power cord Plug into AC outlets Power cord suppliedOperating the system from the remote control Using the remote controlPutting batteries in the remote control Replace the coverPress Enter For TV operationsRelease F TV Try operating your TV by pressing To set the manufacturer’s codeFor VCR operations Release F VCR Try operating your VCR by pressingBasic operations Turning the system on/offSelecting the source to play Adjusting the volumeListening with headphones Turning off the sound temporarilyPress Dimmer Adjusting the brightnessUsing the Sleep Timer Press SleepChanging the decode mode Adjusting the output level of the subwooferAdjusting the bass/treble sound Press Decode to select the decode modePlace a disc on the disc tray PlaybackBasic playback Press the selected Disc 1-5 buttonPlayback information on the display window Resume Playback DVD/Video CD/SVCD onlyOn-screen guide icons Press and hold 7, then press 0for Disc Playback featuresOne Touch Replay Disc information on the display windowLocating the beginning of a desired selection Locating a desired selection using number buttonsFast-forward/fast-reverse search Tune in the station you want to preset Manual tuningPreset tuning Tuner operationsReducing the noise of AM MW broadcast Reception modeSelecting the FM Press RDS Display while listening to an FM station Using the RDS Radio Data System when receiving FM stationsTo show the RDS signals information About characters shown on the display windowPress PTY Search again To search for a program using the PTY codesPress PTY Search while listening to an FM station To continue searching after the first stopTest Switching to broadcast program of your choice temporarilyDescription of the PTY codes How the Enhanced Other Network function actually works CaseDTS Digital Surround Creating realistic sound fieldsDolby Surround DSP modesIndicators on the display window When playing back digital multichannel software Using the surround modePress Surround Mode When playing back 2 channel sourcePress Test Adjusting the soundAdjust the speaker output levels -10 to +10 Press Test again to stop the test toneAdvanced operations Using the on-screen barContents of the on-screen bar during playback Showing the on-screen barChanging the time information Playing from a specified position on a discBasic operation on the on-screen bar Locating a desired scene from the DVD menuPress TITLE/GROUP Locating a desired chapter using the on- screen barLocating a desired title/group using number buttons Locating a desired position by specifying the time Using the MP3 controlDisplay Use number buttons 0-9 to enter the timePress number buttons 0-10, +10 to enter the file number Using the Jpeg control displayPress number buttons 0-10, +10 to enter the track number Press MenuPress Angle Selecting a view angleSelecting a view angle Press Angle repeatedly to select the desired view angleSelecting the audio language Selecting the subtitle/ audio languagesSelecting the subtitle language Audio language Press on Screen twice Selecting the audio channelAdvanced operations Press Cursor //5to select the desired Press Audio repeatedly to select the desired audio channelPlaying back in slow-motion Special picture playbackFrame-by-frame playback ZoomingChanging the VFP setting Press 3 play button to start Program Playback Program PlaybackRepeat to program following orders Repeating the current selection or all discs Random PlaybackRepeat Playback Press RepeatPress Cursor //5 repeatedly to select the Repeat mode Repeating a desired partChoice menus Setting DVD preferencesUsing the choice menus Press Cursor //5 repeatedly to select the desired option Basic operation on the choice menusPress Choice To set other items on the same choice menuLanguage menu Language Language codes listMenu description Audio menu Audio Speaker setting menuPicture menu Picture CenterAdjust the output level of related speakers This item is fixed to USEParental Lock Other setting menu OthersSetting Parental Lock Parental Lock sub-menu appears on the TV screenReleasing Parental Lock temporarily Changing the Parental Lock settingPress number buttons 0-9 to enter your password Country/Area codes list for Parental Lock Press Cursor 3/2 to make an adjustment or selection System settingPress Setting Repeat steps 2 and 3 to set other itemsReferences MaintenanceTrouble shooting GeneralDVD Playback Others MP3 PlaybackJpeg Playback Glossary Refers to individual chapters included in a titleIndex JpegSpecifications TH-M45 DVD Digital Cinema System