Spalding manual 05/05 ID# M866041

Page 17

17. After pole has been secured to plate (2) loosen nut (25), remove cotter pin (37), and pull out pin (36). This will allow the removal of the assembly bolt (14) which is no longer necessary for the remainder of the assembly and installation of system.

WARNING: ONLY AFTER NUTS (24) HAVE BEEN FULLY TIGHTENED:

Remove cotter pin (37) and pin (36) to remove assembly bolt (14) from bottom plate (2).

25

24

35

14

37

36

17

05/05

ID# M866041

Image 17
Contents In-Ground Basketball System Safety Instructions Parts List Hardware Identifier Bolts & Screws Mounting plate 2 and secure as shown Install threaded ends of J-bolts 19 through holesBuild drainage hill Side ViewInsert bushings 27 into areas shown Mounting plate 2 as shown Playing SurfaceCompleted Assembly ID# M866041 05/05 Lower yoke Attach elevator adjustment 12 toAttach elevator adjustment 12 to pole bracket Yokes 18 Attach backboard 10 to upper and lowerRim Assembly Screws 29 into place with a rubber mallet Apply height indicator labels 32 & 31 to height indicatorsInstall net 4 to rim as shown Playing 05/05 ID# M866041 Feet 3.05 m Limited Lifetime Warranty