Amana RST, RSS Cabinet Installation Opening For Gas Slide-In Range, Lo Back Rail Slide-In Model

INSTALLATION INSTRUCTIONS

CABINET INSTALLATION OPENING FOR GAS SLIDE-IN RANGE

A.Cabinet cutout must be prepared as shown in Figure

11.Never install a range over kitchen carpeting.

Figure 11

LO BACK RAIL SLIDE-IN MODEL

B.For electric and gas connection specifications refer to instructions for installing automatic pilotless ignition gas range.

C.On post formed (moulded) tops, shave the front corner of cabinet opening flush with countertop in area which will be underneath front corners of range top (3/8"). (See Figure 12.)

Figure 12

D.On countertops with front metal trim, cut metal trim back 3/8" from front corner of opening. (See Figure --.)

Figure13

ADJUSTMENTS AND LP CONVERSION

NATURAL GAS BURNER ADJUSTMENT

Models Without Sealed Top Burners

and turned fully counterclockwise, the electrode be- tween the flash tubes will start sparking and continue as long as the knob is held in this position. After the burner ignites, move the knob to the "ON" position of the valve. At this time the sparking will cease. There are no standing pilots that have to be lighted or adjusted.

2.Top Burner Adjustment

The air shutter (see Figure 5) should be adjusted to a proper flame. Loosen the air shutter lock screw and adjust the air shutter so the flame has an inner cone of bluish-green and an outer mantle of dark blue. The flame should be soft in character. Tighten the lock screw when the adjustment is complete.

Figure 14

NATURAL GAS BURNER ADJUSTMENT

Models with Sealed Top Burners (Below Serial Number F0430127550)

1.Top Burners

Whenever a top burner gas valve knob is depressed and turned fully counterclockwise, the electrode built into the burner cap will start sparking and continue as long as the knob is held in this position. After the burner lights, move the knob to the "HI" position of the valve. At this time the sparking will cease. There are no standing pilots that have to be lighted or adjusted.

2.Top Burner Adjustment

No gas input adjustment is necessary as the burner is equipped with a fixed orifice. There is no shutter to adjust.

Low burner flame may be adjusted by turning adjust- ment screw in center of valve stem. Normally, the low flame should be adjusted to the minimum steady blue flame. Check the adjustment by turning from high to low several times to see that the burner does not go out.

1. Top Burners		Figure 15
Whenever a top burner gas valve knob is depressed		Top Burner Setting
RC231002 Rev. 3	12	OR