Amana RSS, RST Oven Liner Disassembly Rss Models, Disassembly Procedures - Rst Models

DISASSEMBLY PROCEDURES - RST MODELS

FIRE OR EXPLOSION - TO AVOID THE RISK OF ELECTRICAL SHOCK, PERSONAL INJURY, OR DEATH, DISCONNECT POWER TO THE OVEN BEFORE SERVICING.

4.On models without sealed burners, remove eight (8) screws to burner box.

On models with sealed burners, the burner caps and eight (8) main top mounting screws must be removed. Remove eight (8) burner box mounting screws.

5.Remove bake and broil ignitors. Remove bake and broil burners.

6.Remove lower burner box.

7.Remove oven light lens, light bulb and housing.

8.On ERC models, remove three (3) screws to probe, disconnect wire harness, and remove probe.

On Models without ERC, remove two (2) screws to capillary tube shield and remove shield. Remove capillary tube through top of oven cavity.

9.Remove four (4) screws in top back wall of oven and ten (10) screws securing top combustion chamber to oven liner. Remove two (2) screws to chip cover and four (4) screws at top front of oven liner.

10.Remove storage drawer. Remove one (1) screw from each storage drawer track and remove track from range.

11.Remove eight (8) screws to rear cover.

12.Remove twenty-eight (28) screws securing rear insu- lation retainer. Remove two (2) screws holding dilution flue to rear retainer.

13.Remove four (4) screws securing on backguard sup- port to side panel (either side can be removed).

14.Push down on rear insulation retainer and push up and in on oven liner mounting bracket to free bracket from retainer.

15.Grasp lip of tank and gently maneuver the tank forward to remove it from the range.

16.Remove two (2) screws to each oven liner mounting bracket.

17.Reinstall brackets on replacement liner. Reverse procedure to reinstall replacement liner.

18.Reconnect range to electricity and gas. Be sure to check gas connections for possible leaks. Use a leak detector or soap solution.

OVEN LINER DISASSEMBLY (RSS MODELS)

1.Disconnect electricity at main disconnect plug. Turn off gas supply and disconnect range from gas supply.

2.Remove burner grates, main top, and top burners.

3.Remove burner box.

4.Remove thermostat capillary bulb from capillary shield, and remove capillary shield.

5.Remove oven bottom, oven burner ignitor and oven burner. Also remove broil burner ignitor and broil burner.

6.Remove oven light lens and oven light socket.

7.Remove the ten (10) screws that surround the re- cessed cavity for the broil burner.

Figure 81

8.Remove the four (4) screws mounting on the rear of the oven liner. Remove screws securing front top lip of liner to front frame.

Figure 82

9.Remove the twenty-four (24) screws that secure the recessed cavity fro the oven burner.

Figure 83

10.Remove rear cover plate and screws that secure the insulation retainer.

87 RC231002 Rev. 3