Amana RST Upper Oven Door Assemblies Removal, OVEN DOOR HINGE REMOVAL - Top Hinge - Open oven

UPPER OVEN - RST Models

Upper Oven Door Assemblies Removal

Remove the three (3) screws holding the top hinge to the chassis.

EXTREME CARE SHOULD BE TAKEN TO BE SURE THE DOOR DOES NOT DROP AND BREAK.

NOTE: The unit MUST be clear of overhead cabinets to remove screw.

DISASSEMBLY - Pull gasket from slot in door.

When replacing gasket, be sure it is installed properly and that it seals the door to the chassis when closed.

When replacing the glass, spread the side frame pieces apart slightly. Carefully slide the glass into the frame being sure the gasket stays in place and does not double over on itself. Carefully place top frame piece in place. Be sure the gasket is in place properly and does not fold over when replacing the frame.

HANDLE REMOVAL - Remove the two (2) screws holding the handle to the bottom of the door.

DOOR STRIKE REMOVAL - Remove the control panel. Cut or push away insulation. Use a wrench to remove strike.

DOOR CATCH REMOVAL - Open oven door. Grasp top

	Figure 95
IMPORTANT: It is not necessary to remove the door gasket		and bottom edges of catch with a pliers, squeeze together
(black) when replacing the door glass.	However, caution	and pull catch out of door.
must be taken to be sure the gasket does not stretch or get		OVEN DOOR HINGE REMOVAL - Top Hinge - Open oven
torn when the frame is removed or replaced.
		door to gain access to screws on right side of chassis. Hold
GLASS REMOVAL - Remove door and lay face up on a		door and remove the three (3) screws (black) holding hinge
pad. Remove the two (2) screws on each side of the door		to chassis.
at the top. Carefully slide the top frame piece out of the door		DO NOT ALLOW DOOR TO FALL AND BREAK. LIFT
assembly. The glass can now be lifted out of the door frame.
		DOOR AND HINGE STRAIGHT UP.
		BOTTOM HINGE - Remove top hinge and door. Remove
BE SURE THE GASKETS IN THE FRAME DO NOT COME		three (3) screws (black) holding bottom hinge to oven
		chassis.
OUT WITH THE GLASS. IF A PIECE OF GASKET DOES
COME OUT, REPLACE IT IN THE FRAME BEFORE		NOTE: Door must be leveled when reinstalled. See "Door
REPLACING GLASS.		Alignment".
RC231002 Rev. 3	104