Amana RSS Models with Sealed Top Burners Above Serial Number F0430127550, Lower Oven Burner - Rst

INSTALLATION INSTRUCTIONS

Models with Sealed Top Burners (Above Serial Number F0430127550)

The air shutters (see Figure 6) should be adjusted for a proper flame. Adjust the air shutter so that the flame has an inner cone of bluish-green and an outer mantle of dark blue. The flame should be soft in character. To adjust the air shutter to close the opening to decrease the air or enlarge the opening for more air. Tighten the lock screw when the adjustment is complete.

Low burner flame may be adjusted by turning adjustment screw in center of valve stem. Normally, the low flame should be adjusted to the minimum steady blue flame (approximately 1/4" flame length). Check the adjustment by turning from high to low several times to see that the burner does not go out.

Figure 16

Models with Cast Top Burners

The air shutters (See Figure 7) should be adjusted for a proper flame. Adjust the air shutter so the flame has an inner cone of bluish-green and an outer mantle of dark blue.

For Access to the Air Shutters:

Lift off four (4) burner caps. Remove one (1) screw at each burner body. Pull each burner body upwards and discon- nect the ignition wire at the electrode. Remove one (1) flat headed screw at each burner and lift off main top. Remove plenum box covers (when so equipped).

To Adjust the Air Shutter:

Loosen the lock screw. Move the air shutter to close the opening to decrease the air or enlarge the opening for more air. Tighten the lock screw when the adjustment is com- plete.

Low burner flame may be adjusted by turning adjustment screw in center of valve stem. Normally, the low flame should be adjusted to the minimum steady blue flame (approximately 1/4" flame length). Check the adjustment by turning from high to low several times to see that the burner does not go out. (See Figure 8.)

13

Figure 17

LOWER OVEN BURNER - RST

The appearance of properly adjusted oven burner flame is a bluish-green inner cone and a dark blue mantle. The flame characteristics should be clean and soft with no yellow tips. Blowing or lifting of the flame should not occur.

1.An electric ignitor is used to light the burner. DO NOT attempt to insert any object into the opening of the protec- tive shield surrounding the ignitor coil. Do not attempt to clean this area.

2.The burner flame should be 1/2" long when the air shutter is correctly adjusted. (See Figure 8.) The air shutter is located at the lower right of the access area, above the gas valve. To adjust the air shutter, loosen the lock screw. Move the air shutter to close the opening to decrease the air or enlarge the opening for more air. Tighten the lock screw when the adjustment is complete.

Figure 18

UPPER OVEN BURNER ADJUSTMENT - RST

The burner flames should be 3/8" long when the air shutter is correctly adjusted. The air shutter is located at the left side of the upper oven burner. To adjust the air shutter, loosen the lock screw. Move the air shutter to close the opening to decrease the air or enlarge the opening to increase the air. Tighten the lock screw when the adjust- ment is complete.

RC231002 Rev. 3