Amana RST, RSS service manual Voltage checks good, proce

TROUBLE SHOOTING GUIDE

Electronic Range Control (ERC) (Models w/Two Piece Control)

TO AVOID THE RISK OF ELECTRIC SHOCK, PERSONAL INJURY OR DEATH DISCONNECT POWER BEFORE SERVICING, UNLESS TESTING REQUIRES IT.

	PROBLEMS		POSSIBLE CAUSE		CORRECTION
D. Dim Display - Range		1.	Low supply voltage to	1. Check input voltage at wall o
	may or may not operate.		range.		should be 102 - 132 VAC). I
					VAC, contact power compan
					voltage checks good, proce
		2.	Low input voltage to		Check for 102 - 132 VAC at
			relay/power supply circuit		terminals E1 and E2. If votla
			board.		connections to terminals E1
					good, proceed to Step 3.
			Low relay/power supply	3. Check for 3.2 VAC at relay/p
		3.
			secondary output voltages.		and J1-8, and for 20.3 VAC a
					pins J1-5 and J1-6. If either
					relay/power supply circuit bo
					proceed to Step 4.
			Low input voltages to
		4.	E.R.C.		Check for 3.2 VAC at E.R.C.
					20.3 VAC at E.R.C. pins J1-3
					low, check for loose connec
					voltages check good, proce
			Defective E.R.C.
		5.			If Steps 1 through 5 check g

RC231002 Rev. 3 42