Amana RSS, RST Storage Drawer Panel Liner Rst Models, Drawer Assembly Rst Models, Side Panel Trim

DISASSEMBLY PROCEDURES - RST MODELS

FIRE OR EXPLOSION - TO AVOID THE RISK OF ELECTRICAL SHOCK, PERSONAL INJURY, OR DEATH, DISCONNECT POWER TO THE OVEN BEFORE SERVICING.

STORAGE DRAWER PANEL LINER (RST MODELS)

1.Remove storage drawer from range.

2.Remove six (6) screws securing drawer panel to liner.

3.Remove seven (7) screws securing liner to drawer assembly.

4.Reverse procedure to reinstall.

DRAWER ASSEMBLY (RST MODELS)

1.Remove storage drawer from range.

2.Remove seven (7) screws securing drawer liner to drawer assembly.

3.To replace the drawer assembly, remove the rivets (two (2) each side) securing drawer runners to drawer assembly.

DRAWER RUNNER (RST MODELS)

1.Remove storage drawer from range.

2.Remove two (2) rivets securing drawer runner to drawer assembly. NOTE: The drawer runner "CATCH" and the drawer track "TAB" are color coded. Be sure to match a black drawer runner "CATCH" to a black drawer track "TAB" and gray drawer runner "CATCH" to a gray drawer track "TAB".

SIDE PANEL TRIM

1.Shut off power to the range.

2.Remove oven door and storage drawer.

3.Remove grates, burner bowls, and main top.

4.Remove control panel.

5.Carefully pry trim off of side panel. Reverse proce- dure to reinstall.

DILUTION FLUE

1.Shut off power to the range. Shut off main gas supply and disconnect supply line from range. Slide range away from wall.

2.Remove rear cover and main top.

3.Remove four (4) screws securing backguard to sup- ports. Protect surface of burner box and carefully lay backguard on burner box.

4.Remove two (2) screws securing dilution flue to insulation retainer. Lift up and tilt flue forward to remove. Check gas connections for leaks with soap solution.

INNER FLUE

1.Follow Steps 1 - 4, Dilution Flue Removal.

2.Remove screws securing inner flue to combustion chamber.

3.Reverse procedure to reinstall. Check gas connec- tion for leaks with soap solution.

BROIL BURNER CHAMBER

1.Shut off power to the range. Shut off main gas supply to range and disconnect main gas line to range. Slide range away from wall.

2.Follow Steps 2 - 4, Dilution Flue Removal.

3.Remove screws securing inner flue to broil burner chamber.

4.Remove oven door.

5.Remove broil ignitor and broil burner.

6.Remove four (4) screws in back oven wall and ten (10) screws securing combustion chamber to oven liner.

7.Remove screws securing cup duct (broil burner feed tube and orifice) to combustion chamber.

8.Slide chamber and chamber channels out of range. When reassembling, be sure oven back gasket and channels are in place. Check main gas connection for leaks with leak detector or soapy water.

LOW BACK RAIL, BACK RAIL END CAPS, FLUE COVER TRIM, DILUTION FLUE COVER Models RST307, RST308, RST309

1.Shut off power to the range. Shut off main gas supply and disconnect supply line from range. Pull range away from wall.

2.Remove screws securing end caps to support brack- ets.

3.Remove two (2) screws securing each end cap to low back rail.

4.Remove two (2) screws securing flue cover trim to flue cover.

5.Remove rivets securing flue cover to back rail.

6.Reverse procedure to reinstall. Check main gas connection for leaks with leak detector or soapy solution.

99 RC231002 Rev. 3