TP-Link TL-R4299G manual FCC Statement

Page 3

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Image 3

Contents TL-R4299G Dual-WAN SMB Broadband Router Copyright & Trademarks FCC Statement Package contents Contents Appendix a Specifications Appendix B FAQ Appendix C Glossary Features Overview of the RouterTL-R4299G LED Descriptions Name Action ConventionsPanel Layout Front PanelInstallation Environment Requirements System RequirementsRear Panel Connecting the Router Configure PC Quick Installation GuideDual-WAN SMB Broadband Router User Guide Configure the IP address as shown in -4.After that, click OK Is the connection between your PC and the Router correct? LoginDual-WAN SMB Broadband Router User Guide TL-R4299GDual-WAN SMB Broadband Router User Guide Status Configuring the RouterDual-WAN SMB Broadband Router User Guide Quick Setup Network1 LAN Dynamic IP 2 WANDual-WAN SMB Broadband Router User Guide Static IP PPPoE TL-R4299GDual-WAN SMB Broadband Router User Guide Dual-WAN SMB Broadband Router User Guide BigPondCable L2TP Dual-WAN SMB Broadband Router User Guide Pptp Dual-WAN SMB Broadband Router User Guide Network service detection Flow Balance MAC CloneTo add a dispatch rule Other configurations for the entries as shown in Figure Balance PolicyClick Save Dual-WAN SMB Broadband Router User Guide WAN Port Parameter Dhcp Dhcp SettingsDhcp Clients List To add/modify a reserved IP address Address ReservationVirtual Servers ForwardingTo add/modify a virtual server entry Port Triggering To add/modify a port triggering entry 3 DMZ To assign a computer or server to be a DMZ server UPnPFirewall SecurityIP Filtering To add/modify an IP Address filtering entry TL-R4299GDual-WAN SMB Broadband Router User Guide To add or modify a Domain Filtering entry Domain FilteringMAC Filtering Dual-WAN SMB Broadband Router User Guide Screen ¾ Scan Attack Defence ¾ Dubious Packet Defence ¾ DoS Attack Defence¾ Packet Defence with IP option Static RoutingTo add/modify a static routing entry Session Limit Session LimitTo add/modify a session limit entry Session List QoSQoS Settings QoS Rules ListTo add/modify a QoS rule Binding Setting Setting, ARP List10 IP & MAC Binding To find a specific IP & MAC binding entry To add/modify an IP & MAC binding entryARP List To set up for Dyndns DDNS, follow these instructions Dynamic DNSDyndns Ddns To set up for PeanutHull DDNS, follow these instructions PeanutHull DdnsComexe Ddns To set up for Comexe DDNS, follow these instructions Switch SettingPort Mirror Port StatisticsPort Rate Control Port Parameter Port Status Port Vlan System ToolsTime Settings To configure the system time manuallyTo configure the system automatically Firmware Factory DefaultsTo back up the Router’s current settings Backup and RestoreTo restore the Router’s settings RebootPassword Remote Management System LogStatistics WAN Speed Detect Dual-WAN SMB Broadband Router User Guide IP NAT Table NAT Source Port SettingsPhysical and Environment GeneralAppendix B FAQ Save Want to use Netmeeting, what do I need to do?Method one Use Virtual Server Want to build a WEB Server on the LAN, what should I do? Method two Use DMZ HostFigure B-6 Appendix C Glossary