i n t e l l i g e n t w i r e l e s s | p l a t f o r m |
Figure 2-16 airClient TOTAL Bridge LAN Settings (sB3415-03 Only)
Radio Settings
Follow the steps below to configure the Radio parameters in the airClient TOTAL Bridge Mode, for Non- Transparent bridging :
1.From the navigation menu bar, click on Radio Wireless Settings to set the radio parameters. The Wireless Settings screen will be displayed as shown in Fig
2.Set the SSID, and the wireless mode to either 802.11b/g.
3.The Remote AP MAC Address should be set to 00:00:00:00:00:00.
4.The Channel field will be set to SmartSelect in this mode. (Note: The channel is not configurable in this mode, and will follow the channel of the Access Point, it is associated with.)
5.For the Antenna Selection, choose either Internal or External antenna, as per the requirement.
6.Select the Country for the domain settings.
7.Configure the Distance parameter to configure the Ack Window.
8.Select the Data Rate from the drop down menu. By default, the data rate is set to Best.
9.Set the Default Data Rate to set the data rate for transmitting beacons, broadcast and multicast traffic. By default, this rate is set to 1 Mbps.
10.Select the Transmit power of the radio from the drop down menu.
11.Select the Preamble to be Long or Short. By default the preamble is set to Long.
12.Click on Save to reboot and for the settings to take effect. The unit will attempt to associate after the Reboot.
airClient™ TOTAL 3415 User Guide | Page 31 of 75 |
|