SmartBridges sB3415-03, sB3415-02, sB3415-01 manual Sntp Setting

i n t e l l i g e n t w i r e l e s s p l a t f o r m

The following table summarizes the information for the System Configuration page.

	Table 5-1 System Configuration Page Items
Page Item	Descriptions.
System Name	Name of the airClient TOTAL.
SNMP	This field links to the SNMP Configuration page settings.
Configuration
Reset	This button Resets the airClient TOTAL unit. A message box is prompted to the
	user to confirm the reboot.
SNTP Server	Allows user to set the Network Time Server and Time Zone
Firmware Version	The version of the firmware installed on the unit currently.
Local MAC	The MAC Address of the local airClient TOTAL unit.
Address
Reset to Factory	This button resets the unit to the factory default settings. A message box is
Defaults	prompted to the user to confirm resetting the unit to factory defaults.
Ethernet MTU Size	Displays the Ethernet MTU size.
System Log	This links to the System Log page settings.
Current	Displays the operating mode of the unit.
	This could be Router or NAT for sB3415-01 and sB3415-02 models.
Operational Mode
	This could be Bridge or Router or NAT for sB3415-03 model.

5.2. SNTP Setting

The device time comes from the network time information source. The device needs access to a network timer (NTP time server) source. The NTP time server IP can be configured as follows:

1.From the navigation menu bar, click on Tools SNTP Setting to configure the NTP Server. A page as shown below will appear.

2.Enter a valid SNTP server IP address and select the Time Zone. The default NTP server is 128.250.36.2 and the default Time Zone is Singapore.

3.Click on the Save button to configure the NTP.

4.After the Save/Reboot, the network time will appear on the browser, if the NTP server is contactable.

Figure 5.2 airClient TOTAL SNTP Time Settings
airClient™ TOTAL 3415 User Guide	Page 61 of 75