HARDWARE IDENTIFICATION CHART
This chart is provided to help identify the hardware used in the assembly process. Place the washers, the end of the bolts, or screws on the circles to check for the correct diameter. Use the small scale to check the length of the bolts and screws.
| 3/16" |
| 1/4" | 5/16" | 3/8" |
| 1/2" |
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| INCHES |
|
|
| |
0 | 1/2 |
| 1 | 1/2 | 2 | 1/2 | 3 |
| 1/2 | 4 | 1/2 | 5 | 1/2 | 6 | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| in. |
0 | 10 | 20 | 30 | 40 | 50 | 60 | 70 | 80 | 90 | 100 | 110 | 120 | 130 | 140 | mm. |
150 | |||||||||||||||
|
|
|
|
|
|
|
|
| MILLIMETERS |
| length | ||||
| 6 |
| 8 |
| 10 |
| 12 |
|
|
|
|
|
|
|
|
NOTICE: The length of all bolts and screws except those with flat heads is measured from below the head to the end of the bolt or screw. Flat head bolts and screws are measured from the top of the head to the end of the bolt or screw.
length 
All hardware are already attached to the parts. After unpacking the unit, make sure that you have all the following items on the parts.
Part No. and Description | Qty | |
56 | Carriage Bolt (M8 x 1.25 x 60mm) | 4 |
57 | Carriage Bolt (M8 x 1.25 x 85mm) | 1 |
60 | Screw, Round Head (M5 x 0.8 x 10mm) | 2 |
64 | Bolt, Hex Head (M8 x 1.25 x 20mm) | 4 |
65 | Bolt, Hex Head (M8 x 1.25 x 40mm) | 2 |
69 | Acorn Nut (M8 x 1.25) | 4 |
74 | Arc Washer (M8) | 6 |
75 | Washer (M8) | 5 |
5