SET UP INSTRUCTIONS
Place the INTONE Folding Recumbent Bike in the area where it will be used. It is recommended that the INTONE Folding Recumbent Bike be placed on an equipment mat. The maximum operation dimensions of the INTONE
Folding Recumbent Bike are approximately 42 1/4" long x 25 3/8" wide x 44 1/4" tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 6 feet long is required for safe operation of the INTONE
Folding Recumbent Bike. Make sure that adequate space is available for access to and passage around the INTONE Folding Recumbent Bike.
LEVELING:
MOVING:
Adjust the LEVELING CAPS(50) on the REAR STABILIZER(3) so that the INTONE Folding Recumbent Bike sets on the floor without rocking.
The INTONE | Folding Recumbent Bike has a pair of MOVING WHEELS(48) on the FRONT |
STABILIZER(4). Fold the INTONE Folding Recumbent Bike. Grasp the HANDRAIL(7) and | |
tip the INTONE | Folding Recumbent Bike forward to move. |
Equipment Mat
FUNCTION INSPECTION:
Visually inspect the INTONE
Folding Recumbent Bike to verify that assembly is as shown in the above illustration. Check the function of the INTONE Folding Recumbent Bike. Turn the crank slowly through one complete revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(29) and verify that it functions properly.
CAUTION: Locate and read the WARNING LABEL(77) on the INTONE Folding Recumbent Bike. Make sure that all users read the WARNING LABEL(77).
9