ASSEMBLY INSTRUCTIONS
STEP 11
NOTE: The RIGHT PEDAL(41) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(41) has right hand threads and is tightened by turning clockwise. The LEFT PEDAL(39) has L stamped on the end of the pedal shaft. The LEFT PEDAL(39) has left hand threads and is tightened by turning counterclockwise.
Thread the RIGHT PEDAL(41) into the RIGHT CRANK(37) located inside the CRANK COVER(35) as shown. Tighten the pedal securely. Select the RIGHT PEDAL STRAP(42) which has R marked on the bottom side of the strap. Snap the three hole end onto the inside edge of the RIGHT PEDAL(41). Snap the other end onto the outside edge of the RIGHT PEDAL(41) with the R mark on the bottom of the RIGHT PEDAL STRAP(42). Select adjustment holes which allow your foot to be easily removed from the pedals. Repeat on the left side in order to attach the LEFT PEDAL(39) to the LEFT CRANK(36) and snap the LEFT PEDAL STRAP(40) onto the LEFT PEDAL(39).
STEP 12
Refer to the inset drawing. Plug the PULSE SENSOR WIRE(73) into the socket of PULSE COIL WIRE(74) located on the SEAT CARRIAGE(64). Plug the PULSE COIL WIRE(74) into the socket of PULSE CONNECTION WIRE(75) located on the bracket on the MAIN FRAME(1).
Socket |
10