Assembly Instructions

Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all packing materials from your area and place them back into the box. Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning. If you are missing a part, please go to staminaproducts.com to the Services section and order the part needed, e-mail us at customerservice@staminaproducts.com, or call us toll free at 1-800-375-7520 (in the U.S.). Our Customer Service Staff is available to assist you from 7:30 A.M. to 5:00 P.M. (Central Time) Monday through Thursday and 8:00 A.M. to 3:00 P.M. (Central Time) on Friday.

NOTE: Don’t remove or damage the DECAL(111) located on the top of the MAIN FRAME(1). The DECAL(111) is for preventing the SENSOR WIRE(29) and the PULSE CONNECTION WIRE(75) from dropping into the MAIN FRAME(1).

STEP 1: There is an “R” decal on one end of the FRONT STABILIZER(2). Attach the FRONT STABILIZER

(2)to the MAIN FRAME(1) with the “R” decal end at right side and secure with CARRIAGE BOLTS

(M8x1.25x70mm)(81) and NYLOCK NUTS(M8x1.25)(104).

STEP 2: Insert the STOPPER TUBE(48) through the MAIN FRAME(1) and secure with BUTTON HEAD

BOLT(M8x1.25x15mm)(94).

NOTE: The PEDAL STRAPS(47) are pre-assembled and attached to the FOOT PEDALS(46). The pedal and strap assembly for the left side has an “L” decal. The pedal and strap assembly for the right side has an “R” decal.

STEP 3: Insert the PEDAL SHAFT(44) through the MAIN FRAME(1). Place the RIGHT FOOT PEDAL ASSEMBLY(46R) onto the right end of the PEDAL SHAFT(44) and place the LEFT FOOT PEDAL ASSEMBLY(46L) onto the left end. Secure the FOOT PEDALS with BUTTON HEAD BOLTS (M8x1.25x15mm)(94) and LARGE WASHERS(M8)(109) at both ends of the PEDAL SHAFT(44).

NOTE: You need to use two Allen Wrenches to tighten the BUTTON HEAD BOLTS(M8x1.25x15mm)(94) at both ends of the PEDAL SHAFT(44) at the same time.