SET UP Instructions

Place the AVARI® Conversion II Rower Recumbent Bike in the area where it will be used. It is recommended that the AVARI® Conversion II Rower Recumbent Bike be placed on an equipment mat. The AVARI® Conversion II Rower Recumbent Bike is approximately 77 inches long x 23 inches wide x 33.5 inches tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 8.5 feet long is required for safe operation of the AVARI® Conversion II Rower Recumbent Bike. Make sure that adequate space is available for access to and passage around the AVARI® Conversion II Rower

Recumbent Bike.

LEVELING: Adjust the location of AVARI® Conversion II Rower Recumbent Bike so the bike sits on

the floor without rocking.

MOVING: The AVARI® Conversion II Rower Recumbent Bike has a pair of MOVING WHEELS(76) on the FRONT STABILIZER(2). Grasp the RAIL CAP(55) to move the AVARI® Conversion

II Rower Recumbent Bike.

Equipment Mat (not included)

FUNCTION INSPECTION:

Visually inspect the AVARI® Conversion II Rower Recumbent Bike to verify that assembly is as shown in the above illustration. Check the function of the AVARI® Conversion II Rower Recumbent Bike by turning the crank slowly through one complete revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(27) and verify that it functions properly.

CAUTION: Locate and read the CAUTION LABEL(115) on the AVARI® Conversion II Rower Recumbent Bike. Make sure that all users read the CAUTION LABEL(115) before using the product.