Stamina Products A150-335 owner manual Gap

Page 11

ASSEMBLY INSTRUCTIONS

STEP 13

Insert the SENSOR WIRE(29) and PULSE CONNECTION WIRE(75) into the bottom end of METER POST(31) and pull them out of the top of the METER POST(31). Pull the HANDLEBAR(25), twist the STRAP(21) and slide the strap thru the gap into the hole in the bottom of the METER POST(31). Slide the METER POST(31) onto the MAIN FRAME(1) and secure with SCREW(M5x18mm)(84).

STEP 14

Install two AA batteries into the METER(30), the batteries are not included. See page 13 for detailed battery installation instructions. Plug the SENSOR WIRE(29) and PULSE CONNECTION WIRE(75) into the METER(30) and push the excess wires back into the METER POST(31). Place the METER(30) on the plate on the METER POST(31), then slide it down to lock in position.

NOTE: Please be careful not to damage the Sensor Wires when attaching the METER(30).

Gap

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Stamina Products This Product is Distributed Exclusively bySafety Instructions Table of ContentsCall Us First Avari Conversion II Rower Recumbent Bike Before YOU BeginEquipment WARNING, Caution & Notice Labels Millimeters Hardware Identification ChartAssembly Instructions Step Release Socket Gap Function Inspection SET UP InstructionsFunctions Using the Fitness MeterHOW to Install and Replace Batteries Operational InstructionsRecumbent Bike Mode and Rower Mode Seat AdjustmentMaintenance Load AdjustmentUnfold the Avari Conversion II Rower Recumbent Bike StorageConditioning Guidelines WARM-UP and COOL-DOWN Warranty Limited WarrantyProduct Parts Drawing Part Name Parts ListPART# Part Name To Order Parts To Contact Customer ServiceTo Register Your Product
Top Page Image Contents