2.While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (16) to the Frame with four M8 x 40mm Button Screws (54) and four M8 Split Washers (55).
3.While another person holds the Upright (2) in the posi- tion shown, connect the Upper Wire Harness (42) to the Lower Wire Harness (43). Carefully pull the
upper end of the Upper Wire Harness to remove the slack from the Wire Harnesses.
Make sure that the Upright (2) is turned so the top slopes down in the direction shown. Slide the
Upright onto the Frame (1). Be careful to avoid pinch- ing the Wire Harnesses (42, 43). Attach the Upright to the Frame with four M8 x 40ram Button Screws (54) and four M8 Split Washers (55).
4.Hold the Handlebar (3) near the Upright (2). Feed the Upper Wire Harness (42) up through the indicated hole in the Handlebar. Attach the Handlebar to the Upright with two M8 x 25ram Patch Screws (59) and two M8 Split Washers (55). Be careful to avoid pinching the
Upper Wire Harness.
54
3
Top must
slope down in this direction,
Do not pinch the Wire Harnesses
(42,43) during
55 | this step. |
54,
55
Do not pinch
the Upper
Wire Harness
(42) during
this step.
, _ 42
5