CycleOps 100 PRO Rear stabilizer Front stabilizer Main frame assembly, Handlebar, Small L handles

CHAPTER 2: Unpacking the CycleOps Pro series Indoor Cycle

Place the box upright and cut the plastic binding straps. Lift the top of the box to expose the indoor cycle and packaging. Remove all parts from the box including foam inserts. Ensure all the following parts are included:

	Name	Quantity	Rear stabilizer	A	Front stabilizer	B	Main frame assembly
A	Rear stabilizer	1
B	Front stabilizer	1
C	Main frame assembly	1
D	Handlebar post (shorter, reads to 18”)	1
E	Seat post (longer, reads to 23”)	1
F	Seat	1
G	Seat post clamp	1	Handlebar	D	Seat post	E		Seat
H	Handlebar	1	post
I	Water bottle holder	1
J	End caps	2
K	End cap screws	4		18”		23”
L	Water bottle spacer	1
M	Large L handles	2	Seat post	G	Handlebar	H		Water bottle
N	Small L handles	2	clamp					holder
O	Stabilizer bolts	8
P	Stabilizer washers	8
Q	Multi-purpose wrench	1
R	6mm Allen wrench w/Phillips screw-	1
	driver end
S	5mm Allen wrench	1	End caps	J		K		Water bottle
					End cap screws			spacer
T	4mm Allen wrench	1
U	3mm Allen wrench	1

C

F

I

L

Additional tools that may be helpful: -Vice Grips or small clamping tool -17mm Cone wrench

-15mm box wrench -10mm box wrench -Pliers

-Pedal wrench

-2.5mm Allen wrench

Large L Handles

Stabilizer bolts

M

O

Small L Handles

Stabilizer washers

6mm Allen wrench w/ Phillips screwdriver end

5mm Allen wrench

4mm Allen wrench

3mm Allen wrench

N

P	Multi-purpose	Q
	wrench

R

S

T

U

2