CycleOps 100 PRO, 300 PRO, 400 PRO, 200 PRO manual GEnERAl UsE

Page 7

Attach pedals

If desired, the CycleOps Pro Series indoor cycle can accommodate any standard pedals to personalize the fit, feel and ride. Install using the pedal manufacturer’s specifications. Improper installation can result in damage to the crank. Damage caused by improper pedal installation is not covered under warranty.

Pedal Set

R

Right pedal

Left pedal

L

1.Attach the pedals onto the indoor cycle with the multi-purpose wrench included or a pedal wrench (not included). Each pedal is marked with an “R” or an “L” on the spindle. This mark indicates which side of the indoor cycle the pedal is intended to mount on. This is important because the thread directions are differ- ent for each pedal.

2.Locate the “R” pedal. This pedal is for the right side of the indoor cycle (chain guard side). Turn the spindle clockwise to tighten. Tighten pedals using the multi-purpose wrench or using a pedal wrench to 300 in-lbs.

3.Locate the “L” pedal. This pedal is for the left side of the indoor cycle (no chain guard side). Turn the spindle counter- clockwise to tighten, because this pedal is reverse threaded. Tighten pedals using the multi-purpose wrench or using a pedal wrench to 300 in-lbs.

CHAPTER 4: gEnERAl UsE

The CycleOps Pro Series indoor cycle is easy to use. Adjust the seat and handlebar to alter the ride position. Adjust resistance to change pace/cadence.

Adjust Seat

Large L handle M

Small L handle N

1.Adjust seat position to maximum ex- ercise efficiency, comfort, and reduce risk of injury. Stop the flywheel and dismount the indoor cycle before making adjust- ments.

2.Turn large L handle counterclockwise to loosen. Raise or lower the seat post to the desired height. Turn large L handle clockwise to tighten.

3.Turn small L handle counterclockwise to loosen. Move the seat post clamp and seat forward or back, to achieve proper position. Turn small L handle clockwise to tighten.

6

Image 7
Contents CycleOps Pro Series Indoor Cycles Table of Contents Small L handles Rear stabilizer Front stabilizer Main frame assemblySeat post longer, reads to Seat post clamp HandlebarGuard side Attach Stabilizer FeetLarge L Small L Handles Push Rotate Placement using 6mm Allen wrench Within the clamp. Adjust to desired seatAttach seat to seat post clamp GEnERAl UsE Adjust handlebar Out of the main frame Common AdJUsTmEnTsReplace Hub Batteries 400 Pro/300 Pro only Mm tensioning hardware DAILy Adjust Brake Pad 400 Pro onlyWeekly ElectronicsRadio Frequency RF interference Warranty Manufacturer’s Warranty under normal use