CycleOps 400 PRO, 300 PRO, 200 PRO, 100 PRO manual Common AdJUsTmEnTs, Out of the main frame

Page 9

CHAPTER 5: Common AdJUsTmEnTs

Replace Speed Sensor Battery (200 Pro only)

Over time, the lithium battery in the speed sensor will need to be changed. See Preventative Maintenance for when to replace.

1. Using a 4mm Allen wrench, remove the 2. Locate speed sensor next to hub. three chain guard bolts and remove the

chain guard.

3.Replace the battery with a compatible CR2032.

4.Using the new battery, remove the bat- tery cover on the back of the sensor by turning counterclockwise approximately one half turn.

5.Using a 4mm Allen wrench, and three chain guard bolts, reattach the chain guard.

Replace Cadence Sensor Battery (200 Pro only)

Over time, the lithium battery in the cadence sensor will need to be changed. See Preventative Maintenance for when to replace.

1.Using a 4mm Allen wrench, remove the three chain guard bolts and remove the chain guard.

2.Locate the cadence sensor inside main frame.

3. Using 4mm Allen wrench, remove the bolt attaching the cadence sensor (be sure to hold the cadence sensor arm to avoid dropping the cadence sensor in the main frame). Slide cadence sensor

out of the main frame.

8

Image 9
Contents CycleOps Pro Series Indoor Cycles Table of Contents Seat post longer, reads to Seat post clamp Rear stabilizer Front stabilizer Main frame assemblyHandlebar Small L handlesGuard side Attach Stabilizer FeetLarge L Small L Handles Push Rotate Within the clamp. Adjust to desired seat Placement using 6mm Allen wrenchAttach seat to seat post clamp GEnERAl UsE Adjust handlebar Out of the main frame Common AdJUsTmEnTsReplace Hub Batteries 400 Pro/300 Pro only Mm tensioning hardware DAILy Adjust Brake Pad 400 Pro onlyWeekly ElectronicsRadio Frequency RF interference Warranty Manufacturer’s Warranty under normal use