CycleOps 300 PRO, 400 PRO, 200 PRO, 100 PRO manual DAILy, Adjust Brake Pad 400 Pro only

Page 12

Adjust Brake Pad (100 Pro, 200 Pro, 300 Pro only)

The brake mechanism has been adjusted at the factory. However, over time due to chain stretch and brake pad wear, it may need to be adjusted. To replace/adjust brake pad, use the following procedure:

1.Back off resistance until it the knob

stops turning (counterclockwise). Then turn clockwise 180 degrees (1/2 turn).

Adjust Brake Pad (400 Pro only)

2.Loosen the clamping bolts with a 5mm Allen wrench. Align the brake pad by sliding it towards the flywheel. Stop when the pad just touches the flywheel. Align the arc of the brake pad with the arc of the flywheel.

3.Tighten clamping bolts to 50 in-lbs. When properly adjusted, the CycleOps Pro Series indoor cycle should register around 30 watts at 90 rpm at the lowest resistance setting (can only be validated on 300 Pro).

The brake mechanism has been adjusted at the factory and has an electronically adjusted brake pad. Instead of manually adjust- ing the brake pad, plug the indoor cycle in for 60 seconds and then remove the plug. This resets and places the brake pad in the furthest position (lightest resistance).

CHAPTER 6: PREVEnTATiVE mAinTEnAnCE

Performing necessary preventative maintenance is key to keeping the CycleOps Pro Series indoor cycle in proper working condi- tion. Following the recommended maintenance procedures will help extend the life of the CycleOps Pro Series indoor cycle.

NOTE: Never use abrasive cleaning liquids or petroleum-based solvents when wiping down the indoor cycle. ANy CLEANING LIQ- UIDS MUST BE OF A MILD PH such as Dawn dish washing liquid, Pine Sol, Murphy’s Oil Soap and Mr. Clean. A standard bike polish can be used on the painted parts of the indoor cycle.

DAILy

After each day the indoor cycle is ridden, perform the following:

•Release all tension from the resistance knob.

•Wipe down the handlebar.

•Wipe down seat/seat post.

•Wipe down flywheel.

•Wipe down frame.

•Wipe down chain guard.

•Wipe down resistance knob.

•Wipe down handlebar post.

•Wipe down stabilizers.

11

Page 11 Page 13
Image 12
Page 11 Page 13
Contents CycleOps Pro Series Indoor Cycles Table of Contents Rear stabilizer Front stabilizer Main frame assembly Seat post longer, reads to Seat post clampHandlebar Small L handlesAttach Stabilizer Feet Guard sideLarge L Small L Handles Push Rotate Within the clamp. Adjust to desired seat Placement using 6mm Allen wrenchAttach seat to seat post clamp GEnERAl UsE Adjust handlebar Common AdJUsTmEnTs Out of the main frameReplace Hub Batteries 400 Pro/300 Pro only Mm tensioning hardware Adjust Brake Pad 400 Pro only DAILyElectronics WeeklyRadio Frequency RF interference Warranty Manufacturer’s Warranty under normal use
Top Page Image Contents