Assembly

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

in addition to the included tool(s), assembly requires a Phillips screwdriver _C_===_, two adjustable

wrenches __,

and a rubber mallet _.

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe- ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled.

H 1

M8 Split	16mm	Wave	19mm	Wave	M10 Washer	M8 x 25mm
Washer (83)-9	Washer	(54)-2	Washer	(66)-4	(95)-2	Washer (98)-6

M8 Locknut	M10 Locknut	M4 x 16mm	M8 x 19mm Patch	M8 x 38mm
(1O2)-8	(92)-2	Screw (104)-10	Screw (82)-15	Bolt (96)-8

M8 x 80mm Patch	M10 x 45mm Patch
Screw (84)-2	Screw (99)-4

M10 x 60mm

Bolt (100)-2

ASSEMBLY

(1O2)-8