,
Attach the Front Stabilizer (6) to the Frame (1) with two M8 x 80mm Patch Screws (84).
,Orient the Ramp (3) as shown. Then, insert the Ramp into the Frame (1).
Attach the Ramp (3) with five M8 x 19mm Patch Screws (82) and five M8 Split Washers (83).
,While a second person holds the Upright (4) near the Frame (1), connect the Upper Wire Harness (110) to the Lower Wire Harness (111).
Tip: Avoid pinching the wires. Slide the Upright (4) onto the Frame (1). Attach the Upright with four M8 x 19mm Patch Screws (82) and four M8 Split Washers (83). Do not tighten the Patch Screws yet.
84
82
Avoid pinching
the wires
82
83.83
6